Abstract:In the CBM (Compressed Baryonic Matter) experiment constructed at the Facility for Anti-proton and Ion Research (Fair) at GSI, Darmstadt, Germany, MRPC(Multi-gap Resistive Plate Chamber) is adopted to construct the large TOF (Time-of-Flight) system to achieve an unprecedented precision of hadron identification, benefiting from its good time resolution, relatively high efficiency and low building price. We have developed a kind of double-ended readout strip MRPC. It uses low resistive glass to keep good performance of time resolution under high-rate condition. The differential double stack structure of 2x4 gas gaps help to reduce the required high voltage to half. There are 24 strips on one counter, and each is 270mm long, 7mm wide and the interval is 3mm. Ground is placed onto the MRPC electrode and feed through is carefully designed to match the 100 Ohm impedance of PADI electronics. The prototype of this strip MRPC has been tested with cosmic ray, a 98% efficiency and 60ps time resolution is gotten. In order to further examine the performance of the detector working under higher particle flux rate, the prototype has been tested in the 2014 October GSI beam time and 2015 February CERN beam time. In both beam times a relatively high rate of 1 kHz/cm2 was obtained. The calibration is done with CBM ROOT. A couple of corrections has been considered in the calibration and analysis process (including time-walk correction, gain correction, strip alignment correction and velocity correction) to access actual counter performances such as efficiency and time resolution. An efficiency of 97% and time resolution of 48ps are obtained. All these results show that the real-size prototype is fully capable of the requirement of the CBM-TOF, and new designs such as self-sealing are modified into the strip counter prototype to obtain even better performance.

A Prototype Design of the Readout Electronics of MRPC Detectors in CEE in HIRFL

Readout Electronics Prototype of TOF Detectors in CEE of HIRFL

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Design of a Prototype Readout Electronics with a Few Picosecond Time Resolution for MRPC Detectors

Prototype Front End Electronics of TO Detector in the External Experiment of CSR in HIRFL

R & D of prototype iTOF-MRPC at CEE

Prototype Design of the Time Measurement Circuit for SiPM-based T0 Detector of CEE

FPGA Based Pico-second Time Measurement System for a DIRC-like TOF Detector

Readout Electronics of T0 Detector in the External Target Experiment of CSR in HIRFL

Design and preliminary performance of a novel mixed-signal front-end electronics with post digital shaping for CZT detectors

The Design of a Fast Front-end Readout ASIC for Time Correction with Low Voltage

The Prototype Readout Electronics System for the External Target Experiment in CSR of HIRFL

Development and test of a real-size MRPC for CBM-TOF

A Prototype of the Timing Electronic System for the CALICE SDHCAL

The prototype of the front-end electronics for STCF muon detector

High Resolution Electronics for a Position Sensitive MCP Delay-line Detector

Extensive Beam Test Study of Prototype MRPCs for the T0 Detector at the CSR External-Target Experiment

Design of an Optimised Preamplifier for the MRPC Detector

A High-Density Time-to-Digital Converter Prototype Module for BES III End-Cap TOF Upgrade

Investigation of Electronic Signal Processing Chains for a Prototype TOF-PET System With 100-ps Coincidence Time Resolution

The Readout Electronics Research Design and Development for CEPC Scintillators Electromagnetic Calorimeter Prototype