Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

A Prototype of the Timing Electronic System for the CALICE SDHCAL

Recent developments of the SDHCAL prototype

Design of a Time-to-Digital Converter ASIC and a mini-DAQ system for the Phase-2 upgrade of the ATLAS Monitored Drift Tube detector

Data Acquisition System for CEPC Vertex Detector Prototype

ETROC1: The First Full Chain Precision Timing Prototype ASIC for CMS MTD Endcap Timing Layer Upgrade

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Design and performance of a TDC ASIC for the upgrade of the ATLAS Monitored Drift Tube detector

First Results of the CALICE SDHCAL Technological Prototype

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

A Low-Power Time-to-Digital Converter for the CMS Endcap Timing Layer (ETL) Upgrade

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

A multichannel front end ASIC for PMT readout in LHAASO WCDA

Status of the CALICE analog calorimeter technological prototypes

Prototype Tests for a Highly Granular Scintillator-Based Hadronic Calorimeter

Evaluation of the Timing Performance of the DIET ASIC

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

Prototype of Front-end Electronics for PandaX-4ton Experiment

Performance of a front-end prototype ASIC for the ATLAS High Granularity Timing Detector

R & D of prototype iTOF-MRPC at CEE

A Study of Sensitive Elements of CEPC-AHCAL

Performance of a Front End prototype ASIC for picosecond precision time measurements with LGAD sensors