Abstract:The CDEX (China Dark matter Experiment) is currently in the stage to upgrade to approximately 10 kg HPGe (High Purity Germanium) detectors (CDEX-10) in CJPL (China Jinping Underground Laboratory) and aims to detect the WIMP (Weakly Interacting Massive Particles). Six analog signals and one inhibited signal are outputted from preamplifier by one HPGe detector (∼ 1 kg) of CDEX-10. The analog signals are conditioned with two 6 μs and one 12 μs shaping amplifiers, and three timing amplifiers respectively. The inhibited signal is used for trigger. The analog signals from shaping and timing amplifiers are digitized to obtain energy spectrum and rise-time distribution. The rise-time distribution is used to discriminate surface, bulk, and very bulk events, which can help to supress the background level in dark matter detection. Composed of commercial modules, the previous DAQ (Data Acquisition Systems) is insufficient in discriminating between bulk and very bulk events due to the limited sampling rate (100 MSPS). Besides, as number of channel increases, the system will be simplified by integrating the trigger logic in FPGA (Field Programmable Gate Array). In this paper, a prototype named RAIN4HPGe is designed with pulse digitizer and readout electronics, integrating 14-bit 100 MSPS ADCs (Analog-to-Digital Converters), 12-bit 1 GSPS ADCs, FPGA etc. . The RAIN1000Z1 readout module based on ZYNQ SoC (System on Chip) is used for readout over Gigabit Ethernet. Better energy resolution, e.g. improving from 558 eV to 474 eV @122 keV, can be achieved by RAIN4HPGe compared to previous DAQ (Data Acquisition Systems) with commercial solution. Moreover, the discrimination performance of bulk, and very bulk events has been improved by RAIN4HPGe with 1 GSPS ADC.

Prototype of Front-end Electronics for PandaX-4ton Experiment

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A 500 MS/s waveform digitizer for PandaX dark matter experiments

Data Acquisition System for CEPC Vertex Detector Prototype

Prototype of Pulse Digitizer and Readout Electronics for CDEX-10 in CJPL

Progress and Prospect of PandaX Experiment

Preliminary Design of Pulse Digitalization and Readout Electronics for CDEX-10

An improved design of the readout base board of the photomultiplier tube for future PandaX dark matter experiments

PandaX: a Liquid Xenon Dark Matter Experiment at CJPL

Quantitative Analysis of the High Speed and High Precision Waveform Digital System for Jinping Neutrino Experiment

Improvement on the Linearity Response of PandaX-4T with new Photomultiplier Tubes Bases

The Cryogenics and Xenon handling system for the PandaX-4T Experiment

Improvement on the Linearity Response of PandaX-4T with New Photomultiplier Tube Bases

Prototype of Readout Electronics for GAEA Gamma Spectrometer of Back-n Facility at CSNS

Demonstrating the Q-Pix front-end using discrete OpAmp and CMOS transistors

Low radioactive material screening and background control for the PandaX-4T experiment

Waveform Simulation in PandaX-4T

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

The prototype of the front-end electronics for STCF muon detector

Beam Test of a Monolithic Active Pixel Sensor for the CEPC Vertex Detector

An Analogue Front-End ASIC Prototype Designed For PMT Signal Readout