Abstract:Resistive Plate Chambers (RPC) are cost-effective gaseous detectors with a very good time and spatial resolution which are extensively used in High Energy Physics and Astroparticle experiments. RPCs have also proposed for Time-Of-Flight (TOF) measurements in Positron Emission Tomography (PET) imaging systems. However, the major limitation of common RPC detectors for PET imaging systems is their low detection efficiency for 511 keV gammas. This paper is focused on the development and investigation of a new RPC detector with improved detection efficiency and time resolution for TOF measurement of 511 keV gamma pairs from electron-positron annihilation. The proposed double-stack Multi-gap RPC (MRPC) detector which is optimized for TOF-PET, consists of 20 gas gaps (with 150 μm width) with 180 μm glass slides (with 24% PbO) as resistive plates in optimum thickness to act as the gamma to electron converter. The proposed detector can work at lower applied voltage with higher count rate capability thanks to the double-stack design and smaller gas gaps width in comparison to common RPCs which were used for TOF-PET applications. The experimental detection efficiency of the proposed MRPC detector for single 511 keV gammas is around 8.3%. At higher applied voltages although the electron multiplication of detector increases, but the detection efficiency saturates, which is related to saturation of dark count rate noise. By using the experimental TOF measurement for electron-positron annihilation gammas, the calculated timing standard deviation of each MRPC detector is 194±40 ps. Moreover, in previous work with the proposed detector it was proved that by using a suitable arrangement of vertical and horizontal readout strips, the pixelated detector can be formed to extract the spatial information of the interaction. According to these results, the proposed prototype detector (which is the first double-stack mode MRPC with 20 gas gaps for TOF-PET application) could be a candidate for TOF measurement system thanks to its suitable time and spatial resolution and also reasonable rate capability. Therefore, it could be an inexpensive alternative for commercial TOF-PET detectors.

Design of an Optimised Preamplifier for the MRPC Detector

Study of High Time Resolution MRPC with the Waveform Digitizer System

A Detailed Study on the Intrinsic Time Resolution of the Future MRPC Detector

A Neural Network Based Algorithm for MRPC Time Reconstruction

Development and test of a real-size MRPC for CBM-TOF

A Scalable Digital Pulse Process Module for the MRPC Detector of Muon Tomography

A Front-End Electronics Module for Multi-gap Resistive Plate Chambers

Development of a Sealed MRPC with High Time Resolution

A New Design of MRPC to Reduce Noise and Crosstalk

Improving the Time Resolution of the MRPC Detector Using Deep-Learning Algorithms

Design and Test of a Gluing High Rate MRPC

A Prototype of Strip Readout MRPC for CBM-TOF

Performance Testing of a Long-Strip Two-End Readout Multi-Gap Resistive Plate Chamber

A Cosmic Ray Test Platform Based on High Time Resolution MRPC Technology

A Prototype of a High Rating MRPC

A very thin MRPC developed for TOF-PET

Investigation of a prototype double-stack MRPC detector with 20 gas gaps for Time-Of-Flight measurement in PET imaging systems

Development of a Sealed MRPC with Mylar Spacers for High Luminosity TOF Systems

The Study of a New Time Reconstruction Method for MRPC Read out by Waveform Digitizer

Development of Multi-gap Resistive Plate Chamber (MRPC) for medical imaging

Multigap Resistive Plate Chambers for Time of Flight Applications