Abstract:Background: Rising time discrimination of current pulse signal by using Cs2LiYC16:CE(CLYC), boron plastic scintillator and other neutron gamma detector, analog multi-channel and common digital multi-channel analyzer can not meet the requirements.Purpose:Thisstudy aims to develop ahigh-speed digital multi-channel analyzer. Methods:In this paper, by using the direct coupling way, a special high-speed analog front end circuit is designed. The high-speed analog-to-digital converter (ADC) is connected with field-programmable gate array (FPGA) could realize digital design well, then the system will finish data filtering, pulse amplitude extraction, baseline restorer, spectrum storage, transmission function and so on in the FPGA chip. The universal serial bus (USB) peripheral hangs on the embedded PowerPC kernel, the system can not only simplify the complex timing function of the external controller, but also realize high-speed data transmission with personal computer software. In this work, low noise and high current switching power supply is also designed, finally implemented a hand-held offline independent operation of the high speed digital multi-channel single plate.Results:After the experimental tests, we can see that the digital multi-channel analog front end circuit designed in this paper used in NaI(Tl), boron plastic scintillator, LaBr3(Ce) and other scintillation detector can reach to 110 MHz of large signal bandwidth and climb to 200 MHz of small signal bandwidth. Furthermore, it also has real-time sampling rate of 500 MHz, pulse counting rate by more than 107 s?1, and the linearity is up to 0.9998.Conclusion:The ultimate measured scintillation spectrum in this paper can satisfy the actual requirement.

Design of 32-channel TDC Based on Single FPGA for μSR Spectrometer at CSNS

Design of a 32-Channel NIM TDC Module Based on Single FPGA for the Μsr Spectrometer Prototype at the China Spallation Neutron Source

Resources-limited FPGA based-multi-channel TDC system

Design of a $μ$SR spectrometer with ultrahigh arrays at China Spallation Neutron Source

Design of a Μsr Spectrometer with Ultrahigh Arrays at China Spallation Neutron Source

A 128-Channel High Performance Time-to-Digital Converter Implemented in an UltraScale FPGA

A 16-Channel 15 Ps TDC Implemented in a 65 Nm FPGA

The prototype of the front-end electronics for STCF muon detector

A Sub-10ps Resolution Multichannel Time-to-Digital Converter with Two-Stage Interpolation for High-Energy Physics Applications

Subnanosecond Time-to-Digital Converter Implemented in a Kintex-7 FPGA

Conceptual Design and Update of the 128-Channel Μsr Prototype Spectrometer Based on Musrsim

Design and Realization of High Precision Time-interval Measurement Based on FPGA

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors

Development of a Data Acquisition System for the Μsr Spectrometer Prototype at the China Spallation Neutron Source

130+ ps Coincident Time Resolution With 20mm Crystal Length Using 28 nm Xilinx FPGA

A 19.6 ps, FPGA-Based TDC With Multiple Channels for Open Source Applications

A 128-Channel, 710 M Samples/Second, and Less Than 10 Ps RMS Resolution Time-to-Digital Converter Implemented in a Kintex-7 FPGA

A 3.9 ps RMS resolution time-to-digital converter using dual-sampling method on Kintex UltraScale FPGA

A 4.2 Ps Time-Interval Rms Resolution Time-To-Digital Converter Using A Bin Decimation Method in an Ultrascale Fpga

Design of handheld 500-MHz digital multi-channel analyzer on single board

An FPGA-based, High-Precision, Narrow Pulse Width Measurement Time-to-digital Converter