Abstract:Comparing with the traditional construction process, 3D printing technology used in construction offers many advantages due to the elimination of formwork. Currently, 3D printing technology used in the construction field is widely studied, however, limited studies are available on the dynamic properties of 3D printed materials. In this study, the effects of sand to binder ratios and printing directions on the fractal characteristics, dynamic compressive strength, and energy dissipation density of 3D printed cement mortar (3DPCM) are explored. The experiment results indicate that the printing direction has a more significant influence on the fractal dimension compared with the sand to binder ratio (S/B). The increasing S/B first causes an increase and then results in a decline in the dynamic compressive strength and energy dissipation of different printing directions. The anisotropic coefficient of 3DPCM first is decreased by 20.67%, then is increased by 10.56% as the S/B increases from 0.8 to 1.4, showing that the anisotropy is first mitigated, then increased. For the same case of S/B, the dynamic compressive strength and energy dissipation are strongly dependent on the printing direction, which are the largest printing in the Y-direction and the smallest printing in the X-direction. Moreover, the fractal dimension has certain relationships with the dynamic compressive strength and energy dissipation density. When the fractal dimension changes from 2.0 to 2.4, it shows a quadratic relationship with the dynamic compressive strength and a logarithmic relationship with the energy dissipation density in different printing directions. Finally, the printing mortar with an S/B = 1.1 is proved to have the best dynamic properties, and is selected for the 3D printing of the designed field barrack model.

Rheological Properties and Printability Evaluation of 3d Printing Mortar with Recycled Powder

Mortar with Substituted Recycled PET Powder: Experimental Characterization and Data-Driven Strength Predictive Models

Fresh Properties of 3D Printed Mortar with Recycled Powder

Rheology of Fiber-Reinforced Mortar for 3D Printing Construction: Effect of Recycled Hybrid Powder and Polyethylene Fiber

Mechanical Properties and Pore Structure of 3D Printed Mortar with Recycled Powder

Comparative Evaluation of the Applicability of 3D Printing Mortar with Different Waste Powders

On rheology of mortar with recycled fine aggregate for 3D printing

Effects of Printing Paths and Recycled Fines on Drying Shrinkage of 3d Printed Mortar

Rheological Properties of Mortar Containing Recycled Powders from Construction and Demolition Wastes

Systematic approach for printability evaluation and mechanical property optimization of spray-based 3D printed mortar

3D Recycled Mortar Printing: System Development, Process Design, Material Properties and On-Site Printing

Latest development of 3D printing adopting recycled aggregate

Fiber-reinforced Mortar with 100% Recycled Fine Aggregates: A Cleaner Perspective on 3D Printing

Experimental Investigations on the Rheological Properties of the Proposed 3D Printing Mortar

Printability And Advantages Of 3d Printing Mortar With 100% Recycled Sand

Dynamic Properties and Fractal Characteristics of 3D Printed Cement Mortar in SHPB Test

Early‐age Behavior and Mechanical Properties of Cement‐based Materials with Various Types and Fineness of Recycled Powder

Study on the essential properties of recycled powders from construction and demolition waste

Rheology of 3D Printable Concrete Prepared by Secondary Mixing of Ready-Mix Concrete

Mechanical Performance Optimization in Spray-Based Three-Dimensional-Printed Mortar Using Carbon Fiber

Sustainable 3D printed mortar with CO<sub>2</sub> pretreated recycled fine aggregates