Abstract:To fulfil the requirements of pumpability and buildability, the rheological properties of mortar/concrete for 3D printing should follow much stricter requirements than traditional-cast mortar/concrete. This study proposed to use a secondary CO 2 mixing technique coupled with the addition of silica fume (SF) to achieve in-situ rheology control of 3D printed mortar. The influences of CO 2 mixing on the properties of the cast mortar and the 3D printed mortar prepared with SF were systematically studied. The pH, conductivity and ion concentration were tested to revel the essential chemical reactions and phase evolutions during CO 2 mixing. It was found that the CO 2 mixing effectively enhanced the early-age penetration resistance and yield stress of mortar incorporated with SF, and thus significantly improved the buildability of 3D printed mortar, while the maximum printing layer increased higher than 33 layers. Meanwhile, the mechanical properties of the SF-incorporated mortar were improved by this process. It was revealed that during the CO 2 mixing process, the injected CO 2 rapidly reacted with calcium ions to form CaCO 3 , which further reacted with C 3 A to form monocarboaluminate (Mc). The fast precipitation of calcium ions during CO 2 mixing accelerated the hydration of C 3 A and C 3 S, contributing to the rapid development of strength at early ages and the improved performance of hardened mortar. The addition of SF in mortar greatly amplified the beneficial effect of CO 2 mixing, which due to SF as nucleation sites promoted the formation of CaCO 3 and Mc during CO 2 mixing.

A new strategy to enhance 3D printability of cement-based materials: In-situ polymerization

Improvements in the Printability of Printed Mortar Using In-Situ Polymerization

A novel method for improving the printability of cement-based materials: Controlling the releasing of capsules containing chemical admixtures

Effects of in-situ Polymerization on Mechanical Properties of 3D Printing Mortars and Its Mechanism

Improving mechanical properties of 3D printed mortar by exploiting synergistic effects of fly ash microsphere and nano-silica

Multi-scale Structure of In-Situ Polymerized Cementitious Composites with Improved Flowability, Strength, Deformability and Anti-Permeability

Effect of polyacrylamide on the workability and interlayer interface properties of 3D printed cementitious materials

Modification effect of nanosilica and polypropylene fiber for extrusion-based 3D printing concrete: Printability and mechanical anisotropy

Enhancing Clay-Based 3D-Printed Mortars with Polymeric Mesh Reinforcement Techniques

The Synergistic Effect of Greenhouse Gas CO2 and Silica Fume on the Properties of 3D Printed Mortar

Systematic approach for printability evaluation and mechanical property optimization of spray-based 3D printed mortar

The synergistic effect of greenhouse gas CO 2 and silica fume on the properties of 3D printed mortar

Analysis of rheological properties and printability of a 3D-printing mortar containing silica fume, hydrated lime, and blast furnace slag

A Novel Approach for 3D Printing Fiber-Reinforced Mortars

Improving printability of limestone-calcined clay-based cementitious materials by using viscosity-modifying admixture

Factors Influencing the Properties of Extrusion-Based 3D-Printed Alkali-Activated Fly Ash-Slag Mortar

Thermally stimulated stiffening and fly ash's alkaline activation by Ca(OH) 2 addition facilitates 3D-printing

Mechanical Performance Optimization in Spray-Based Three-Dimensional-Printed Mortar Using Carbon Fiber

3D Printing of Fiber-Reinforced Calcined Clay-Limestone-Based Cementitious Materials: From Mixture Design to Printability Evaluation

Stiffening Controllable Concrete Modified with Redispersible Polymer Powder for Twin-Pipe Printing

Development of a Novel Extrusion Device to Improve the Printability of 3D Printable Geopolymer Concrete