Abstract:Membrane humidification is the most prevalent method used to humidify the fuel cell system of commercial vehicles. However, this passive approach meets only the humidity requirements. In order to simultaneously address the issues of humidification and cooling associated with high-power fuel cell systems,air-assisted atomization humidification (AAAH) is proposed as an active technology. However, there are not enough experiments to evaluate the adaptation of AAAH. In this study, the impacts of spray parameters are observed under high-power load conditions and then compared with that of membrane humidification (MH) under various operating scenarios. Experimental results show a positive correlation between the relative humidity of the cathode inlet and the pressure of spray with AAAH. Moreover, this technology achieves higher relative humidity of the cathode inlet and water recovery rate than those obtained by MH, enhancing the stack performance and system efficiency and reducing system thermal load. At the rated current of 540 A, the system efficiency can reach up to 44.8 %. Although the humidity fluctuates in the range of 26.3 % to 53.2 % under variable load conditions, with a response time of 41 s, which is longer than that of MH, the fluctuations are within an acceptable limit considering the stack performance. Finally, an optimized control strategy based on the proportion of liquid water is applied to achieve the reuse of humidification from the liquid water removal at the cathode outlet at full operating conditions.

Preparation and Performance of a Self-Humidifying Fuel Cell Using a Fiber Sintered Sheet As Flow Field

Preparation of a self-humidifying membrane electrode assembly for fuel cell and its performance analysis

Numerical studies of liquid water behaviors in PEM fuel cell cathode considering transport across different porous layers

Proton Exchange Membrane Fuel Cell with Humidifying Zone

Multi-sub-inlets at Cathode Flow-Field Plate for Current Density Homogenization and Enhancement of PEM Fuel Cells in Low Relative Humidity

Improvement of Thermal and Water Management of Air-Cooled Polymer Electrolyte Membrane Fuel Cells by Adding Porous Media into the Cathode Gas Channel

In-situ Measurement of Temperature and Humidity Distribution in Gas Channels for Commercial-Size Proton Exchange Membrane Fuel Cells

Self-humidifying effect of air self-circulation system for proton exchange membrane fuel cell engines

Liquid Water Transport and Mechanical Performance of Electrospun Gas Diffusion Layers

Numerical and experimental investigations on internal humidifying designs for proton exchange membrane fuel cell stack

Design of a New Single-Cell Flow Field Based on the Multi-Physical Coupling Simulation for PEMFC Durability

A Capillary Water Retention Effect to Improve Medium-Temperature Fuel Cell Performance

Uncoupling Characteristics Of Temperature And Relative Humidity Distribution In A Commercial-Size Polymer Electrolyte Membrane Fuel Cell

Comprehensive performance evaluation of air-assisted atomization humidification for high-power fuel cell systems

Single-walled carbon nanotube interlayer modified gas diffusion layers to boost the cell performance of self-humidifying proton exchange membrane fuel cells

Enhancing Heat Removal and H2O Retention in Passive Air-Cooled Polymer Electrolyte Membrane Fuel Cells by Altering Flow Field Geometry

Comparison of Self-Humidification Effect on Polymer Electrolyte Membrane Fuel Cell with Anodic and Cathodic Exhaust Gas Recirculation

Designing self-humidifying proton exchange membrane fuel cells by using patterned acid-alkaline hybrid cathodes

A Metallic Gas Diffusion Layer and Porous Media Flow Field for Proton Exchange Membrane Fuel Cells

Flow Field Design with 3D Geometry for Proton Exchange Membrane Fuel Cells

Numerical and Experimental Investigation of the Asymmetric Humidification and Dynamic Temperature in Proton Exchange Membrane Fuel Cell