Abstract:Absorption heat pumping devices (AHPDs, comprising absorption heat pumps and chillers) are devices that use thermal energy instead of electricity to generate heating and cooling, thereby facilitating the use of waste heat and renewable energy sources such as solar or geothermal energy. Despite this benefit, widespread use of AHPDs is still limited. One reason for this is partly unsatisfactory control performance under varying operating conditions, which can result in poor modulation and part load capability. A promising approach to tackle this issue is using dynamic, model-based control strategies, whose effectiveness, however, strongly depend on the model being used. This paper therefore focuses on the derivation of a viable dynamic model to be used for such model-based control strategies for AHPDs such as state feedback or model-predictive control. The derived model is experimentally validated, showing good modeling accuracy. Its modeling accuracy is also compared to alternative model versions, that contain other heat transfer correlations, as a benchmark. Although the derived model is mathematically simple, it does have the structure of a nonlinear differential-algebraic system of equations. To obtain an even simpler model structure, linearization at an operating point is discussed to derive a model in linear state space representation. The experimental validation shows that the linear model does have slightly worse steady-state accuracy, but that the dynamic accuracy seems to be almost unaffected by the linearization. The presented new modeling approach is considered suitable to be used as a basis for the design of advanced, model-based control strategies, ultimately aiming to improve the modulation and part load capability of AHPDs.

Control-oriented modeling of direct-heat co-current rotary dryers for energy demand flexibility

Optimal Control Structure Selection Based on Economics for Continuous Cross-Flow Grain Dryer

Performance Simulation of a Modified Geothermal Grain Dryer Based at Menengai Well 3 in Kenya

Design Model of Pan Rotary Dryer and Tube Rotary Dryer

Heat and Mass Transfer in Agitated, Co-, or Countercurrent Conductive–Convective Heated Drum Dryer

Control-oriented modeling of a LiBr/H2O absorption heat pumping device and experimental validation

Heat and Mass Transfer Simulation of Intensification Drying Technologies: Current Status and Future Trends

Modeling the Value of Flexible Heat Pumps

A Simulation Study of Heat and Mass Transfer in A Honeycombed Rotary Desiccant Dehumidifier

An Investigation of Heat Transfer of Flexible Fibers in a Rotating Drum Dryer Using the Discrete Element Method

On-line evaluation of moisture transfer properties for a feed-forward control of a wood drying kiln with a mechanistic model

Dynamic modeling of the steam supply system for a paper drying cylinder

SIMULATION OF BIOMASS DRYING IN A DIRECT CONTACT ROTARY DRYER

A Study for Estimating the Overall Heat Transfer Coefficient in a Pilot-Scale Indirect Rotary Dryer

A Computational Analysis of Heat and Mass Transfer in an Indirect Evaporative Cooler Using the Spray Dryer Model

Theoretical and experimental research on heat and mass transfer in a turbine thin layer dryer

Experimental and computational validation of thermal performance of an active greenhouse solar dryer in no-load conditions

Mathematical Modeling of the Process of Operation of the Drying Chamber of a Tower Grain Dryer With a Suction Air Flow

Superheated steam drying of single wood particles: A characteristic drying curve model deduced from continuum model simulations and assessed by experiments

A control-oriented mathematical model for the evolution of temperatures and phases in a steel strip during cooling