Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

Dynamic modeling of the steam supply system for a paper drying cylinder

Modeling and Simulation of Multi-Cylinder Paper Drying Processes

Modeling of a pneumatic system for high-accuracy position control

Research on the Mixed Logical Dynamical Model of the Hot Blast Stove

Valve Dynamic and Thermal Cycle Model in Stepless Capacity Regulation for Reciprocating Compressor

Energy and mass transfer dynamic prediction model of the conditioning cylinder: modeling and applications research

MD‐CD Interaction Modeling and Control of Paper Machines

SIMULATION MODELS OF MULTI-CYLINDER PAPER DRYING

Research on Hybrid Modeling Simulation Method of Steam Dynamic Transmission and Distribution Process

Dynamic Modeling and Control Programme Simulation for Sterilization Cauldron

Dynamic Modeling and Simulation of Drum-Steam Pressure Based on Lots of On-Line Data

Modelica-based heating surface modelling and dynamic exergy analysis of 300 MW power plant boiler

Virtual process control system and its employment on the pulp & paper industry

A Lumped-Parameter Model of Multiscale Dynamics in Steam Supply Systems

Control-oriented modeling of direct-heat co-current rotary dryers for energy demand flexibility

Dynamic Model Establishment and Analysis on Gas-solid Flow in CFB Whole Loop

Experimental analysis of convective drying of paper and board

A Study on Energy Storage Characteristics of Industrial Steam Heating System Based on Dynamic Modeling

Long-term Dynamic Model and Simulation of Steam Turbines

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Research on Dynamic Modeling of the Supercritical Carbon Dioxide Power Cycle