Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

An Investigation of Heat Transfer of Flexible Fibers in a Rotating Drum Dryer Using the Discrete Element Method

Simulation of Biomass Pyrolysis in a Rotary Drum by Coupling CFD-DEM with a One-Dimensional Thermally Thick Model

Wall to particle bed contact conduction heat transfer in a rotary drum using DEM

Multi-level Coarse-Grained Discrete Element Method Modeling of Cylinder Particle Flow in a Rotating Drum

DEM investigation of heat transfer in a drum mixer with lifters

Numerical investigation of the particle flow behaviors in a fluidized-bed drum by CFD-DEM

Study on heat and mass transfer characteristics in drying process of drum dryer based on the DEM-CFD coupled method

DEM simulation and analysis of particle mixing and heat conduction in a rotating drum

Modeling and simulation of drying characteristics on flexible filamentous particles in rotary dryers

DEM investigation of the axial dispersion behavior of a binary mixture in the rotating drum

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

Simulation of Dynamic Processes on Flexible Filamentous Particles in the Transverse Section of A Rotary Dryer and Its Comparison with Ideo-Imaging Experiments

Three-dimensional axial dispersion dynamics of granular flow in the rolling-regime rotating drum

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Study on heat and mass transfer of flexible filamentous particles in a rotary dryer

Heat transfer of cohesive particles in a rotary drum: Effect of material properties and processing conditions

Some Considerations for Measuring the Collisional Dissipation Rate of Flexible Fibers

Heat transfer in indirect heated rotary drums filled with monodisperse spheres: Comparison of experiments with DEM simulations

DEM Simulation of Heat Transfer in Granular Materials

The impact of changing drum rotation direction on fabric motion and drying performance in clothes dryers