Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Some Considerations for Measuring the Collisional Dissipation Rate of Flexible Fibers

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

A Bonded Sphero-Cylinder Model for the Discrete Element Simulation of Elasto-Plastic Fibers

Development of a Collisional Dissipation Rate Model for Frictional Cylinders

Fiber Reinforcement on Spherical Granular Beds under Triaxial Compressions

Using the discrete element method to develop collisional dissipation rate models that incorporate particle shape

Discrete Element Method Model of Elastic Fiber Uniaxial Compression

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization

Breakage of Wet Flexible Fiber Agglomerates Impacting a Plane

Discrete Element Method Models of Elastic and Elastoplastic Fiber Assemblies

Collisional Dissipation Rate for Binary Mixtures of Aspherical Particles

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Collisional Dissipation Rate in Shearing Flows of Granular Liquid Crystals.

Effects of Fiber Shape on Mechanical Properties of Fiber Assemblies

Granular Damping Analysis Using a Direct Simulation Monte Carlo Approach

Discrete Element Simulations of Flexible Ribbon-Like Particles

Discrete Element Method Simulations for Complex Granular Flows

On the Influence of Inter-Particle Friction and Dilatancy in Granular Materials: a Numerical Analysis

Numerical simulation on velocities of two interacting fibers in fiber suspension

Some Considerations on the Rheology of Dense Frictional Cylindrical Particles

Mechanistic Studies of Initial Deposition of Fine Adhesive Particles on a Fiber Using Discrete-Element Methods