Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Discrete Element Simulations of Flexible Ribbon-Like Particles

A Bonded Sphero-Cylinder Model for the Discrete Element Simulation of Elasto-Plastic Fibers

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Investigation of Modeling Non-Spherical Particles by Using Spherical Discrete Element Model with Rolling Friction

Discrete Element Method Simulations for Complex Granular Flows

Three-dimensional Simulation of Gas-Solid Flow in a Fluidised Bed with Flexible Ribbon Particles

A spheropolyhedral-based discrete element lattice Boltzmann method for simulation of non-spherical adhesive particulate flow

A high-performance discrete-element framework for simulating flow and jamming of moisture bearing biomass feedstocks

A new discrete element method for small adhesive non-spherical particles

CFD-DEM Modeling of Rod-Like Particles in a Fluidized Bed with Complex Geometry

A deformable spheropolygon-based discrete element method

A fast adhesive discrete element method for random packings of fine particles

General Polygon Mesh Discrete Element Method for Arbitrarily Shaped Particles and Complex Structures Based on an Energy-Conserving Contact Model

Elastic Deformable Particle Model in Discrete Element Method

A Composite Particle Model for Non-Spherical Particles in DEM Simulations

Discrete Simulation of Particle Manipulation in Micro-Fluid with Acoustic Force

Discrete element modeling of switchgrass particles under compression and rotational shear

Discrete Element Method Model of Elastic Fiber Uniaxial Compression

A nonlinear elasto-plastic bond model for the discrete element modeling of woody biomass particles

Numerical Simulation of the Injection Molding Process of Short Fiber Composites by an Integrated Particle Approach

A Cubic Arranged Spherical Discrete Element Model