DESIGN AND EXPERIMENTAL VERIFICATION OF SELF-PRIMING HOT AIR TEMPERATURE CHANGING DEVICE FOR GRAIN DRYER
Zhao-Xin LIU,Gang CHE,Lin WAN,Hong-chao WANG,Zheng-Fa CHEN,Hao-Chen WANG
DOI: https://doi.org/10.35633/inmateh-73-26
2024-08-27
INMATEH Agricultural Engineering
Abstract:During the grain drying process, in order to adjust the temperature, it is necessary to match the proportion of hot and cold air. This is the problem that the two components in the mixed gas cannot fully mix with each other in a short period of time, resulting in the problem that it takes a long time for the gas flow temperature to reach a stable value. Based on the process and technical requirements of the dryer, a self-priming hot air temperature changing device suitable for the dryer was designed. The two gas components used to improve the variable temperature ratio of the dryer are fully mixed with each other in a short time and a short distance, thereby reducing the loss caused by the food not reaching safe moisture. Based on Bernoulli's principle and the basic theory of airflow mixing in fluid dynamics, a mathematical model of airflow mixing in the constriction section of the main pipeline was established. Fluent was used to numerically simulate the distribution of uniform mixing distance and temperature field in the necking section. The results show that the mixing uniformity in the necking section reaches 75%-80%, which effectively improves the mixing efficiency. A self-priming hot air temperature change device test bench developed independently was used, and the quadratic orthogonal rotation combined test method was used for parameter optimization. Design-Expert.V8.0.6.1 was used for analysis and testing, and the regression equation and response surface were obtained to analyze the effects. Interaction between factors to determine the best combination of optimization parameters: when the number of air inlet pipes is 3.16, the incision axial angle is 27.6°, the temperature difference is 43.5°C, and the pipe diameter is 23.8mm, the post-mixing temperature is 50.93°C, and the mixing distance is uniform is 39.33mm. The test results are consistent with the optimization results. The self-priming hot air temperature changing device of the dryer has certain practical application value.