Abstract:We report high thermoelectric performance in nanostructured p-type PbS, a material consisting of highly earth abundant and inexpensive elements. The high level of Na doping switched intrinsic n-type PbS to p-type and substantially raised the power factor maximum for pure PbS to ~9.0 μW cm(-1) K(-2) at >723 K using 2.5 at. % Na as the hole dopant. Contrary to that of PbTe, no enhancement in the Hall coefficient occurs at high temperature for heavily doped p-type PbS, indicating a single band model and no heavy hole band. We also report that the lattice thermal conductivity of PbS can be greatly reduced by adding SrS or CaS, which form a combination of a nanostructured/solid solution material as determined by transmission electron microscopy. We find that both nanoscale precipitates and point defects play an important role in reducing the lattice thermal conductivity, but the contribution from nanoscale precipitates of SrS is greater than that of CaS, whereas the contribution from point defects in the case of CaS is greater than that of SrS. Theoretical calculations of the lattice thermal conductivity based on the modified Callaway model reveal that both nanostructures and point defects (solid solution) effectively scatter phonons in this system. The lattice thermal conductivity at 723 K can be reduced by ~50% by introducing up to 4.0 at. % of either SrS or CaS. As a consequence, ZT values as high as 1.22 and 1.12 at 923 K can be achieved for nominal Pb(0.975)Na(0.025)S with 3.0 at. % SrS and CaS, respectively. No deterioration was observed after a 15 d annealing treatment of the samples, indicating the excellent thermal stability for these high performance thermoelectrics. The promising thermoelectric properties of nanostructured PbS point to a robust low cost alternative to other high performance thermoelectric materials.

High Thermoelectric Properties with Low Thermal Conductivity Due to the Porous Structure Induced by the Dendritic Branching in N-Type PbS

Enhanced thermoelectric performance of n -type PbTe bulk materials fabricated by semisolid powder processing

Microstructure and thermoelectric properties of porous Bi 2 Te 2.85 Se 0.15 bulk materials fabricated by semisolid powder processing

High Thermoelectric Efficiency Of N-Type Pbs

High Thermoelectric Performance in PbTe Due to Large Nanoscale Ag2Te Precipitates and La Doping

High Performance Thermoelectrics from Earth-Abundant Materials: Enhanced Figure of Merit in Pbs Through Nanostructuring Grain Size

High Performance Thermoelectrics from Earth-Abundant Materials: Enhanced Figure of Merit in PbS by Second Phase Nanostructures.

Thermoelectrics with Earth Abundant Elements: High Performance P-Type PbS Nanostructured with SrS and CaS

Realizing high-ranged thermoelectric performance in PbSnS2 crystals

Promoting SnTe As an Eco‐Friendly Solution for P‐pbte Thermoelectric Via Band Convergence and Interstitial Defects

Multiscale structure and band configuration tuning to achieve high thermoelectric properties in n-type PbS bulks

Enhanced thermoelectric performance of hot-press Bi-doped n-type polycrystalline PbS

High Performance Na-doped PbTe-PbS Thermoelectric Materials: Electronic Density of States Modification and Shape-Controlled Nanostructures.

Thermoelectric enhancement for n-type PbS via synergistic effect of Ti doping and Cu2S compositing

Band Sharpening and Band Alignment Enable High Quality Factor to Enhance Thermoelectric Performance in N-Type PbS.

High Performance of N-Type (Pbs)(1-X-y)(pbse)(x)(pbte)(y) Thermoelectric Materials

High Carrier Mobility Promotes In‐Plane Thermoelectric Performance of N‐type PbSnS2 Crystals

Achieving Higher Thermoelectric Performance of N-Type PbTe by Adjusting the Band Structure and Enhanced Phonon Scattering

Enhanced Thermoelectric Performance of N-Type PbTe Through the Introduction of Low-Dimensional C60 Nanodots

An Approach of Enhancing Thermoelectric Performance for P-Type PbS: Decreasing Electronic Thermal Conductivity

High-Ranged <i>ZT</i> Value Promotes Thermoelectric Cooling and Power Generation in n-Type PbTe