Abstract:The control method of the drive axis was investigated with the goal of rapid startup of the MEMS gyroscope with a high Q-factor .The change rate of the vibration phase of the high Q-factor resonator with frequency was analyzed ,and the reason for the long starting time of the phase-locked loop scheme in addition to its sensitivity to the initial frequency deviation was elucidated . The variation rule of the amplitude at the initial stage of the self-excited oscillation scheme with time was deduced by using the averaging method .A control scheme that combines the self-exited oscillation loop and the phase-locked loop (SEOL-PLL ) of the drive axis was proposed .The self-excited oscillation mode was used to quickly start the gyroscope ,and then the phase-locked loop was used to maintain the accuracy and stability of the vibration frequency .In the experiment ,when the initial frequency deviation of the PLL is less than ± 10 Hz ,the starting time of the gyroscope is 2 s . Whereas with the SEOL-PLL scheme ,a frequency error of 0 .01％ is achieved in 0 .3 s and an amplitude error of 0 .1％ is achieved in 0 .4 s ,as long as the initial frequency deviation is within ± 1000 Hz .The "SEOL-PLL" solution considerably reduces the start-up time and is insensitive to the initial frequency deviation of the gyroscope .It is therefore suitable for the mass production of MEMS gyroscope and has a good adaptability to ambient temperature change .

A Fast-Startup Self-Sustained Thermal-Piezoresistive Oscillaror with >106 Effective Quality Factor in the Air

Self-Oscillating Calorimeter Based on Thermal-Piezoresistive Resonator

A Thermal-Piezoresistive Self-Sustained Resonant Mass Sensor with High-Q (>95k) in Air

A Self-Sustained Mass Sensor with Physical Closed Loop Based on Thermal-Piezoresistive Coupled Resonators

Dual-Mode Thermal-Piezoresistive Coupled Resonators for Fast and Stable NIR Measurements with Differential Output

On the Dynamic Range and Resolution of Thermal-Piezoresistive Resonant Mass Sensors

Wafer-Level Vacuum-Packaged High-Performance AlN-on-SOI Piezoelectric Resonator for Sub-100-MHz Oscillator Applications

A Million-order Effective Quality Factor MEMS Resonator by Mechanical Pumping

A Piezoelectric Width-Flexural Mode MEMS Resonator with High Quality Factor and Low Motional Resistance

A Novel Resonant MEMS Accelerometer Operating in Air with Thermally Actuated Piezoresistive Resonators

Mode Selection Behavior of VHF Thermal-Piezoresistive Self-Sustained Oscillators

High Quality Factor Silicon Cantilever Driven by PZT Actuator for Resonant Based Mass Detection

Thermal nonlinearities in a nanomechanical oscillator

Ultra-sensitive magnetic field sensor based on a low-noise magnetoelectric MEMS-CMOS oscillator

Rapid start-up control of high Q-factor MEMS gyroscope

A Temperature-Stable and Low Impedance Piezoelectric MEMS Resonator for Drop-in Replacement of Quartz Crystals

Q-enhancement of Piezoelectric Micro-Oven Controlled MEMS Resonators Using Honeycomb Lattice Phononic Crystals

A Single-Pixel Sensor for Near-field Imaging Based on Startup Time of Oscillator

Piezoelectric Characterization of a Single Zinc Oxide Nanowire Using a Nanoelectromechanical Oscillator

Zinc oxide nanowire electromechanical oscillator

Investigation Of Nano Sic Resonator