Abstract:In this article, a wideband quasi-circulator (QC) with the low noise figure (NF) and high 1-dB compression point ( $\text{P}_{\text {1 dB}}$ ) is proposed. The slotline-based 180° hybrid is introduced to achieve the wideband high transmitter-receiver (TX-RX) isolation. Meanwhile, the bidirectional in-phase stage and the nonreciprocal out-of-phase stage are utilized to obtain specific power-split ratios for the low insertion loss and high antenna-transmitter (ANT-TX) isolation. By using the unequal power split, the proposed QC is without the fundamental 3-dB loss seen in reciprocal ANT interfaces. Besides, to further enhance the TX-RX isolation within a wideband, a reconfigurable inter-stage matching network based on a varactor-tuned capacitor is implemented. To verify the mechanisms mentioned above, a reconfigurable wideband QC operating at 1.75–2.9 GHz is implemented and fabricated. The total power consumption is 224 mW. The measurement exhibits in-band TX-RX isolation of 27–58 dB. The TX-ANT and ANT-RX insertion losses are 4.3–5.0 dB and 1.0–1.9 dB, respectively. The QC also achieves the minimum in-band ANT-RX NF of 3.4 dB. Meanwhile, the measured TX-ANT and ANT-RX IIP3s are 39.4 and 32.5 dBm, respectively. The TX input $\text{P}_{\text {1 dB}}$ is greater than 28.78 dBm, while the RX input $\text{P}_{\text {1 dB}}$ is 23 dBm. The TX-induced ANT-RX $\text{P}_{\text {1 dB}}$ is measured to be 28 dBm.

Integrated Active Quasi-Circulator with 27 Db Isolation and 0.8–6.8ghz Wideband by Using Feedback Technique

A Highly-integrated Non-magnetic Passive Circulator Based on Rotary Traveling-wave Oscillator and Spatio-temporal Conductivity Modulation in 130 Nm CMOS

A Dual Interference-Canceling Active Quasi-Circulator Achieving 36-Db Isolation over 6-Ghz Bandwidth

A Wideband Active Quasi-Circulator with 34-Db Isolation and Insertion Loss of 2.5 Db

A survey of active quasi-circulators

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

A Wideband CMOS Frequency Quadrupler with Transformer-Based Tail Feedback Loop.

Active Quasi-Circulator Based on Wilkinson Power Divider for Miniaturized Wireless Communication System

A Full-duplex Transceiver with Integrated Active Quasi-circulator Achieving Self-interference RF Cancellation over Wide Bandwidth

A Compact X-band Circulator with Embedded Feed Line Based on Substrate Integrated Waveguide

Design of CMOS Integrated Circulator Based on Sequentially Switched Delay Lines with Body-Floating and Clock Boosting Techniques

A Wideband Quasi-Circulator with Low NF and High P-1dB Using Noise-Canceling Technique

A Wideband Switched-Capacitor Circulator Based on Isolation Improvement Technique with Transformers

Magnet-Free Miniaturized Circulator Based on Non-Reciprocal Network

Low NF and High P1dB Wideband Quasi-Circulator with Unequal Power Split and Reconfigurable Inter-Stage Matching

A Compact Quasi -Circulator with High Isolation Using Reconfigurable 180° Hybrid

Integrated Superconducting Isolator-Circulator-Isolator Device

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

A Magnetless Filtering Circulator With Enhanced Isolation Bandwidth Using Mixed Static and Time-Modulated Resonators

Design and Fabrication of Self-biased Microstrip Double-Y Junction Circulator

Broadband Eight‐way Substrate Integrated Coaxial Line Power Divider with High Isolation