Abstract:This article presents ultra-wideband and low-noise distributed active quasi-circulators (QCs) fabricated using a 28-nm CMOS process. The proposed active QCs use a differential two-stage distributed amplifier (DA) design, where the electrical length of the input and output transmission lines is 90 $^\circ$ at 28 GHz. For the ultra-wideband distributed active QC (UWQC), the differential outputs of the amplifier in the second stage are cross-connected to the differential outputs of the amplifier in the first stage, resulting in ultra-wideband isolation regardless of the frequency. In addition, an interstage inductor is inserted in the amplifiers to maintain the frequency response of the input and output transmission lines identically. For the low-noise distributed active QC (LNQC), the resistive termination at the input transmission line of DA is eliminated by using input-matched amplifiers, resulting in a low antenna (ANT) -to-receiver (RX) noise figure (NF). In addition, the LNQC with the input-matched amplifiers allows a 3-dB higher transmitter (TX)-to-ANT gain compared to conventional distributed QC. Moreover, the transistor size and bias condition of the input-matched amplifiers can be selected to achieve low noise and high power handling capability of the QC within a given tradeoff. The measured results demonstrate that the UWQC achieves 20.5 $-$ 35.5-GHz wideband operating bandwidth with TX-to-ANT gain of 4.5 dB, ANT-to-RX insertion loss of 3.6 dB, and $>$ 21-dB TX-to-RX isolation, only occupying a die area of 0.07 mm $^2$ . The LNQC achieves ANT-to-RX NF of 8.9 $-$ 11.1 dB, which is around 10 dB lower than the conventional distributed QC. The measured TX-to-ANT output power 1-dB compression point is 14.3 dBm with a dc power consumption of 28.6 mW, occupying a die area of 0.25 mm $^2$ .

A Wideband Quasi-Circulator with Low NF and High P-1dB Using Noise-Canceling Technique

Low NF and High P1dB Wideband Quasi-Circulator with Unequal Power Split and Reconfigurable Inter-Stage Matching

A Wideband Active Quasi-Circulator with 34-Db Isolation and Insertion Loss of 2.5 Db

0.9–10GHz low noise amplifier with capacitive cross coupling

A Compact Quasi -Circulator with High Isolation Using Reconfigurable 180° Hybrid

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Compact mm-Wave Ultra-Wideband and Low-Noise Phase Alternately Distributed Quasi-Circulators

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

Tunable Quasi-Circulator Based on a Compact Fully-Reconfigurable 180° Hybrid for Full-Duplex Transceivers.

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A Gm-boosted and current peaking wideband merged LNA and mixer

A Dual Interference-Canceling Active Quasi-Circulator Achieving 36-Db Isolation over 6-Ghz Bandwidth

Integrated Active Quasi-Circulator with 27 Db Isolation and 0.8–6.8ghz Wideband by Using Feedback Technique

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 22.9–38.2-Ghz Dual-Path Noise-Canceling LNA with 2.65–4.62-Db NF in 28-Nm CMOS

An Ultra-Compact 84.9-107Ghz LNA with 4.9db NF by Utilizing Coupled-line-based Gm-Boosting and Noise-Canceling Techniques in 65-Nm CMOS Technology

A 5-Ghz Inductor-Noise Cancelling Receiver with 1.8 Db Noise Figure in 65nm LP CMOS

A 5.6-Db Noise Figure, 63–86-Ghz Receiver Using a Wideband Noise-Cancelling Low Noise Amplifier with Phase and Amplitude Compensation

A wideband inductorless LNA exploiting three-stage feedback and thermal noise canceling

A Full-duplex Transceiver with Integrated Active Quasi-circulator Achieving Self-interference RF Cancellation over Wide Bandwidth

A Q-band CMOS LNA with noise cancellation