Abstract:A wideband noise-cancelling low-noise amplifier (LNA) without the use of inductors is designed for low-voltage and low-power applications. Based on the common-gate-common-source (CG-CS) topology, a new approach employing local negative feedback is introduced between the parallel CG and CS stages. The moderate gain at the source of the cascode transistor in the CS stage is utilized to boost the transconductance of the CG transistor. This leads to an LNA with higher gain and lower noise figure (NF) compared with the conventional CG-CS LNA, particularly under low power and voltage constraints. By adjusting the local open-loop gain, the NF can be optimized by distributing the power consumption among transistors and resistors based on their contribution to the NF. The optimal value of the local open-loop gain can be obtained by taking into account the effect of phase shift at high frequency. The linearity is improved by employing two types of distortion-cancelling techniques. Fabricated in a 0.13-mu m RF CMOS process, the LNA achieves a voltage gain of 19 dB and an NF of 2.8-3.4 dB over a 3-dB bandwidth of 0.2-3.8 GHz. It consumes 5.7 mA from a 1-V supply and occupies an active area of only 0.025 mm(2).

A 5-Ghz Inductor-Noise Cancelling Receiver with 1.8 Db Noise Figure in 65nm LP CMOS

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

An Inductor-Less Highly Linear LNA with Noise Cancelling and Current Reusing for 3–5 GHz Low-Power UWB Receivers

A Hybrid Coupler-First 5ghz Noise-Cancelling Dual-Mode Receiver with +10dbm In-Band IIP3 in Current-Mode and 1.7db NF in Voltage-Mode.

A Low Power Inductorless Wideband LNA With G m Enhancement and Noise Cancellation

6.7 A 1.75dB-NF 25mW 5GHz Transformer-Based Noise-Cancelling CMOS Receiver Front-End

A 0.1–3.5-Ghz Inductorless Noise-Canceling CMOS LNA with IIP3 Optimization Technique

A Low Power Direct Conversion Receiver RF Front-End with High In-Band IIP2/IIP3 and Low 1/f Noise

Inductorless CMOS Low Noise Amplifier for Multiband Application in 0.1–1.2 GHz

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

A 0.03-3GHz Wideband Inductorless Receiver in 65nm CMOS

A CMOS 0.5&#x2013;10.6 GHz Inductor Feedback Low Noise Amplifier for Multi-Standard Application

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A 5 Ghz 7.2 Db Nf Low Power Direct Conversion Receiver Front-End with Balun Lna

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

A 6-18Ghz Low-Noise Amplifier Using Noise Canceling Technique in 130-Nm CMOS PD-SOI.

A 5.6-Db Noise Figure, 63–86-Ghz Receiver Using a Wideband Noise-Cancelling Low Noise Amplifier with Phase and Amplitude Compensation