Abstract:In power converters with high switching frequency, drive losses constitute a significant portion of the overall power losses. Resonant gate drivers can reduce drive losses, thereby enhancing the efficiency. However, resonant drivers suffer certain challenges: parameter drifts lead to the mismatch between the resonant frequency and the control frequency, and this mismatch can cause gate-to-source voltage overshoot. Moreover, the resonant driver is susceptible to external interference. This paper proposes a resonant circuit structure and control timing scheme aimed at overcoming these limitations. By incorporating a half-bridge clamp circuit, the proposed design achieves voltage clamping, thereby insulating the system from disturbances caused by mains power fluctuations. When there is a mismatch in resonant frequencies, the strategy employs a combination of hardware circuit diodes and control system timing to prevent overvoltage issues. Additionally, the utilization of MOSFETs minimizes the loss caused by prolonged current flow through body diodes, further reducing the resonant driving losses. Simulations have demonstrated the system’s stability under varying resonant parameters and its effective anti-interference capabilities in voltage clamping. Experiments achieved a power saving of 83.3% at a 1 MHz operating frequency. Both simulations and experimental validations confirm the feasibility of the proposed solution, its effectiveness in interference suppression, handling of resonant mismatches, and its role in further augmenting power conservation.

Resonant Gate Driver for High Speed GaN HMET with Dv/dt Control

A 2–10 MHz GaN HEMTs Half-Bridge Driver with Bandgap Reference Comparator Clamping and Dual Level Shifters for Automotive Applications

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

A GaN HEMTs Half-Bridge Driver with Bandgap Reference Comparator Clamping for High-Frequency DC-DC Converter.

A GaN HEMT Gate Driver IC with Programmable Turn-on Dv/dt Control

A High-Speed Low Side GaN E-Hemt Driver with Gate Ringing and Overshoot Suppression.

A Resonant Drive Circuit for GaN Power MOSHFET

An Efficient High-Frequency Drive Circuit for GaN Power HFETs

A 400-V Half Bridge Gate Driver for Normally-off GaN HEMTs with Effective dv/dt Control and High dv/dt Immunity

Monolithic GaN-Based Driver and GaN Switch With Diode-Emulated GaN Technique for 50-MHz Operation and Sub-0.2-ns Deadtime Control

A Monolithic GaN Driver and GaN Power Switch with Power-rail Charging Saturation Bootstrap technique achieving gate rising and falling time ratio of 1.28

Gate Drive Design Considerations for Enhancement-mode GaN Power Devices

Study of High-Frequency Resonant Gate Drivers

High-Speed Gate Driver Using GaN HEMTs for 20-MHz Hard Switching of SiC MOSFETs

Monolithic Integration of Gate Driver and Protection Modules with P-GaN Gate Power HEMTs

A novel active gate drive for HV-IGBTs using feed-forward gate charge control strategy

An Up to 10mhz 6.8% Minimum Duty Ratio GaN Driver with Dual-MOS-Switches Bootstrap and Adaptive Short-Pulse Based High-CMTI Level Shifter Achieving 6.05% Efficiency Improvement

High-Frequency Three-Level Gate Driver for GaN HEMT Bridge Crosstalk Suppression

Gate drive design considerations for high voltage cascode GaN HEMT

Research of High Frequency Drive Circuit for Motor Drive System Based on GaN Power Device

Resonant Gate Drive Circuit with Active Clamping to Increase Efficiency and Reliability