Abstract:As power efficiency becomes essential in automotive applications, DC-DC converters are widely employed [1]. However, size and thermal limits have made it challenging to continue using standard CMOS-based converters. Gallium Nitride (GaN) FETs, on the other hand, have a much higher conductivity with small size/capacitance in comparison to silicon FETs, enabling a highly efficient power conversion at high switching frequency (f SW ). However, there are several issues that must be resolved before using GaN in automotive. High f SW incurs larger di/dt and dv/dt transitions which injects high frequency electromagnetic interference (EMI) noise into the input bus. This creates unwanted noise or even a malfunction in a safety-critical system. A bulky input filter can reduce EMI, but it greatly increases size and cost. Several techniques [2-5] are reported to mitigate EMI. Frequency hopping using discrete frequencies is proposed in [2], but cannot spread the frequency evenly to lower the peak noise effectively. Alternatively, a series resistor is typically added at the gate of the GaN FET to slow down the transition [3-4]. However, the switching loss is dramatically increased. To mitigate this, adjustable driving strength is proposed in [5]. Unfortunately, the sensing and driver delays confine its use in low f SW applications, where the switch node rising time is several tens or hundreds of ns. Another issue of high f SW operation is that it causes significant current and voltage spikes due to the parasitics at the drain/source of the high side GaN FET (M H ), which could lead to GaN VDS breakdown or damage on logic-level FETs. Thus, EMI noise suppression and reliable operation of GaN FETs remain as major challenges in realizing high f SW power converters for automotive-use.

A Resonant Drive Circuit for GaN Power MOSHFET

An Efficient High-Frequency Drive Circuit for GaN Power HFETs

A 2–10 MHz GaN HEMTs Half-Bridge Driver with Bandgap Reference Comparator Clamping and Dual Level Shifters for Automotive Applications

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

Resonant Gate Driver for High Speed GaN HMET with Dv/dt Control

Monolithic GaN-Based Driver and GaN Switch With Diode-Emulated GaN Technique for 50-MHz Operation and Sub-0.2-ns Deadtime Control

High-Speed Gate Driver Using GaN HEMTs for 20-MHz Hard Switching of SiC MOSFETs

A High-Speed Low Side GaN E-Hemt Driver with Gate Ringing and Overshoot Suppression.

A Monolithic GaN Driver and GaN Power Switch with Power-rail Charging Saturation Bootstrap technique achieving gate rising and falling time ratio of 1.28

Gate Driver Design for SiC Power MOSFETs with a Low-Voltage GaN HEMT for Switching Loss Reduction and Gate Protection

A Novel Gate Control Strategy for 3.4kv Cascade Sic Mosfets Stack

Research of High Frequency Drive Circuit for Motor Drive System Based on GaN Power Device

Gate Drive Design Considerations for Enhancement-mode GaN Power Devices

Monolithic Integration of Gate Driver and Protection Modules with P-GaN Gate Power HEMTs

GaN Power IC Technology on P-Gan Gate HEMT Platform

An Integrated Gate Driver Based on SiC MOSFETs Adaptive Multi-Level Control Technique

High Reliability GaN FET Gate Drivers for Next-generation Power Electronics Technology

Study of High-Frequency Resonant Gate Drivers

Gate drive design considerations for high voltage cascode GaN HEMT

Modeling the Gate Driver IC for GaN Transistor: A Black-Box Approach