Abstract:For ultra-high-speed digital transmission, required by 5G/6G communications, ultra-wideband common-mode rejection (CMR) structures with autonomous phase-balancing capability are proposed. Common-mode noise, caused by phase and amplitude unbalances, is one of the most undesired disturbances affecting modern digital circuits. According to the circuit design guides with a typically used differential line (DL) for high-speed digital transmission, common-mode rejection is achieved using CMR filters, and the unbalanced phase, caused by a length difference between the two signal lines of a DL, is compensated by inserting an additional delay line. However, due to nonlinear phase interactions between the two DLs and unbalanced electromagnetic (EM) interferences, the conventional compensation method is frequency-limited at around 10 GHz. To significantly enhance the common-mode rejection level and extend the phase recovery bandwidth, the proposed CMR structure utilizes a planar balanced line (BL), such as a coplanar stripline (CPS) or a parallel stripline (PSL), along with additional conductor strips arranged laterally near the BL. To demonstrate the performance of the proposed BL-based CMR structures, various types of CMR structures are fabricated, and the measurement results are compared with the 3D EM simulation results. As a result, it is proven that the proposed BL-based CMR structures have the capability to reject the common-mode noise with suppression levels of more than 10 dB and to simultaneously recover the phase balance from near DC to over 40 GHz.

A U-shaped Complementary Open Loop Defective Ground Structure with Slow Wave Structure for Mode Conversion and Common Mode Noise Suppression

Slow-wave structure to suppress differential-to-common mode conversion for bend discontinuity of differential signaling

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

An Asymmetric Spiral-Shaped Dgs Optimized by Genetic Algorithm for Wideband Common-Mode Suppression

A 28 GHz LNA using defected ground structure for 5G application

A Compact Meander Line-Resonator Hybrid Structure for Wideband Common-Mode Suppression

An Alternating High‐low Impedance Common‐mode Filter for Differential Striplines

Design of a wideband common-mode filter using approximate closed-loop pattern of compact C-shaped defected ground structure

A novel wideband common-mode suppression filter for differential signal transmission

Mixed-Mode Property of Defected Ground Structure and Its Application in Balanced Network Design with Harmonic Suppression

A Novel Compact Dual-Functional Circuit With Differential-Mode Equalization and Broadband Common-Mode Suppression Using Patterned Ground Plane

Ultra-Wideband Common-Mode Rejection Structure with Autonomous Phase Balancing for Ultra-High-Speed Digital Transmission

Improving Signal Integrity by Reducing Mode Conversion in Differential Pairs on a Meshed Ground in Flexible Printed Circuit Boards

A Novel Coplanar Common-Mode Filter with A Wide Stopband

A Compact Common-Mode Suppression Filter for Differential Signal Transmission with Slow-Wave Structure

Analysis of Signal Propagation in High-Speed Differential Signal Lines with Full-Wave Time-Domain Technique

An Ultra-Wideband Common-Mode Noise Filter for Differential Signals Using Compact Patterned Ground Structure

A Novel Combined Equivalent Networks Analysis for Power and Ground Planes with Narrow Slots

DG-side earth fault tolerance enhancement based on topology improvement and common and differential mode control strategy

A New Structure for Broadband Transition Between Differential Stripline and Differential GCPW