Abstract:For ultra-high-speed digital transmission, required by 5G/6G communications, ultra-wideband common-mode rejection (CMR) structures with autonomous phase-balancing capability are proposed. Common-mode noise, caused by phase and amplitude unbalances, is one of the most undesired disturbances affecting modern digital circuits. According to the circuit design guides with a typically used differential line (DL) for high-speed digital transmission, common-mode rejection is achieved using CMR filters, and the unbalanced phase, caused by a length difference between the two signal lines of a DL, is compensated by inserting an additional delay line. However, due to nonlinear phase interactions between the two DLs and unbalanced electromagnetic (EM) interferences, the conventional compensation method is frequency-limited at around 10 GHz. To significantly enhance the common-mode rejection level and extend the phase recovery bandwidth, the proposed CMR structure utilizes a planar balanced line (BL), such as a coplanar stripline (CPS) or a parallel stripline (PSL), along with additional conductor strips arranged laterally near the BL. To demonstrate the performance of the proposed BL-based CMR structures, various types of CMR structures are fabricated, and the measurement results are compared with the 3D EM simulation results. As a result, it is proven that the proposed BL-based CMR structures have the capability to reject the common-mode noise with suppression levels of more than 10 dB and to simultaneously recover the phase balance from near DC to over 40 GHz.

An Asymmetric Spiral-Shaped Dgs Optimized by Genetic Algorithm for Wideband Common-Mode Suppression

Design of a wideband common-mode filter using approximate closed-loop pattern of compact C-shaped defected ground structure

Design of a Novel Ultra-Wideband Common-Mode Filter Using a Magnified Coupled Defected Ground Structure

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

A 28 GHz LNA using defected ground structure for 5G application

A compact common-mode filter for GHz differential signals using defected ground structure and shorted microstrip stubs

Compact Substrate Integrated Waveguide (SIW) Filter with Defected Ground Structure

A Wideband Digital Variable Gain Amplifier with DC Offset Cancellation in SiGe 0.18µm BiCMOS Technology

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

A U-shaped Complementary Open Loop Defective Ground Structure with Slow Wave Structure for Mode Conversion and Common Mode Noise Suppression

Notice of Retraction: A Novel Coplanar Common-Mode Filter with a Wide Stopband

Wideband Electromagnetic Interference Filtering Power Divider With Wide Stopband Using Genetic Algorithm

An Alternating High‐low Impedance Common‐mode Filter for Differential Striplines

A Compact Meander Line-Resonator Hybrid Structure for Wideband Common-Mode Suppression

UWB Bandpass Filter with Wide Notch Using Hybrid Microstrip/cpw Scheme, Defected Microstrip Array, and Defected Corner Scheme

A Common-Mode Noise Suppression Filter for Gigahertz Differential Signals Based on Substrate Integrated Waveguide Resonators

Wideband Bandpass Filter with High Selectivity Based on Dual‐mode DGS Resonator

A Novel Compact Dual-Functional Circuit With Differential-Mode Equalization and Broadband Common-Mode Suppression Using Patterned Ground Plane

Modeling And Measurement Of A Common-Mode Filter Based On The 3-D Transmission Line Structure

Ultra-Wideband Common-Mode Rejection Structure with Autonomous Phase Balancing for Ultra-High-Speed Digital Transmission

Compact Differential Diplex Filtenna With Common-Mode Suppression for Highly Integrated Radio Frequency Front-Ends