Abstract:For ultra-high-speed digital transmission, required by 5G/6G communications, ultra-wideband common-mode rejection (CMR) structures with autonomous phase-balancing capability are proposed. Common-mode noise, caused by phase and amplitude unbalances, is one of the most undesired disturbances affecting modern digital circuits. According to the circuit design guides with a typically used differential line (DL) for high-speed digital transmission, common-mode rejection is achieved using CMR filters, and the unbalanced phase, caused by a length difference between the two signal lines of a DL, is compensated by inserting an additional delay line. However, due to nonlinear phase interactions between the two DLs and unbalanced electromagnetic (EM) interferences, the conventional compensation method is frequency-limited at around 10 GHz. To significantly enhance the common-mode rejection level and extend the phase recovery bandwidth, the proposed CMR structure utilizes a planar balanced line (BL), such as a coplanar stripline (CPS) or a parallel stripline (PSL), along with additional conductor strips arranged laterally near the BL. To demonstrate the performance of the proposed BL-based CMR structures, various types of CMR structures are fabricated, and the measurement results are compared with the 3D EM simulation results. As a result, it is proven that the proposed BL-based CMR structures have the capability to reject the common-mode noise with suppression levels of more than 10 dB and to simultaneously recover the phase balance from near DC to over 40 GHz.

Modeling And Measurement Of A Common-Mode Filter Based On The 3-D Transmission Line Structure

A Compact Meander Line-Resonator Hybrid Structure for Wideband Common-Mode Suppression

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

An Alternating High‐low Impedance Common‐mode Filter for Differential Striplines

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

TSV-based common-mode noise-suppressing filter design and implementation

Notice of Retraction: A Novel Coplanar Common-Mode Filter with a Wide Stopband

A Common-Mode Noise Suppression Filter for Gigahertz Differential Signals Based on Substrate Integrated Waveguide Resonators

The design and test of dual/triple-mode bandpass filter based on temporal coupled-mode theory

Common Mode Interference Modeling and Measurement for Cascaded Photovoltaic Grid-Connected System Module

Novel Bandpass Filters by Using Cavity-Loaded Dielectric Resonators in A Substrate Integrated Waveguide

Electrical Modeling of Three-Dimensional Carbon-Based Heterogeneous Interconnects

Scalable RFCMOS Model for 90 Nm Technology

Design of Absorptive Common-Mode Filters Based on Coupled Stripline λ/4 Resonator

Design of a wideband common-mode filter using approximate closed-loop pattern of compact C-shaped defected ground structure

High Frequency Modeling for Common Mode Chokes Based on Impedance Measurement

Modeling and Analyzing High-Order Modes in Periodic-Stub-Loaded Stripline for Wideband Filter Design

A General Analytical Model of Single-Layer Common-Mode Chokes

Ultra-Wideband Common-Mode Rejection Structure with Autonomous Phase Balancing for Ultra-High-Speed Digital Transmission

Characteristics research for planar common mode EMI filter based on toroidal LC coil

An Asymmetric Spiral-Shaped Dgs Optimized by Genetic Algorithm for Wideband Common-Mode Suppression