Abstract:Partial discharge (PD) detection is an effective method for finding insulation defects in HV and EHV power cables. PD apparent charge is typically expressed in picocoulombs (pC) when the calibration procedure defined in IEC 60270 is applied during off-line tests. During on-line PD detection, measured signals are usually denoted in mV or dB without transforming the measured signal into a charge quantity. For AC XLPE power cable systems, on-line PD detection is conducted primarily with the use of high frequency current transformer (HFCT). The HFCT is clamped around the cross-bonding link of the joint or the grounding wire of termination. In on-line occasion, PD calibration is impossible from the termination. A novel on-line calibration method using HFCT is introduced in this paper. To eliminate the influence of cross-bonding links, the interrupted cable sheath at the joint was reconnected via the high-pass C-arm connector. The calibration signal was injected into the cable system via inductive coupling through the cable sheath. The distributed transmission line equivalent circuit of the cable was used in consideration of the signal attenuation. Both the conventional terminal calibration method and the proposed on-line calibration method were performed on the coaxial cable model loop for experimental verification. The amplitude and polarity of signals that propagate in the cable sheath and the conductor were evaluated. The results indicate that the proposed method can calibrate the measured signal during power cable on-line PD detection.

An ACRF Technique for PD Detection of XLPE Cables Based on Equivalent Pulse Width Modulation and Time Domain Reflectometry Denoising

Radio-frequency Detection of Partial Discharge in Power Cable Joints

A Novel Variable-frequency Resonant System for Partial Discharge Detection of XLPE Cables

An Improved Variable-Frequency Series Resonant System for PD Detection of MV Power Cables Based on DAC Technology

An Adaptive Pulse Separation Strategy for PD Detection in Frequency-Tuned Resonant Tests

Partial discharge detection in XLPE power cable with CT sensor

Experimental research on partial discharge localization in XLPE cable accessories using multi sensor joint detection technology

A Pulse Interference Suppression Method Based on Double-Sensor Detection for PD Measurement in Frequency-Tuned Resonant Tests

The Application of Partial Discharge Detection for the Condition Assessment of Xlpe Power Cables

Detection Method Of Partial Discharge In Xlpe Cable Accessories Based On The Method Of Vhf Combined With Acoustic Emission

On-site Partial Discharge Detection of Power Cables Using a Novel DAC Technique Supplied by a Capacitor Bank

An Improved Design of Damped AC Test System for Partial Discharge Measurement in Distribution Power Cables

A Thermal Excitation Based Partial Discharge Detection Method for Cable Accessory

Distributed Partial Discharge Detection Technology for High Voltage Cable Based on Ac Withstand Voltage

A Comparative Study on Partial Discharge Characteristics for XLPE Cable.

On-line Calibration of Partial Discharge Monitoring for Power Cable by HFCT Method

RESEARCH AND DEVELOPMENT OF ON-LINE MONITORING SYSTEM WITH PARTIAL DISCHARGE IN XLPE POWER CABLES

A Low-cost DAC System for On-site PD Testing of HV Cables Based on ACRF and Capacitor Bank

A Cost-Effective Technique for PD Testing of MV Cables under Combined AC and Damped AC Voltage

Partial Discharge Pattern Recognition of XLPE Cables at DC Voltage Based on the Compressed Sensing Theory

Development of the Accurate Localization of Partial Discharges in Medium‐voltage XLPE Cables Based on Pulse Reconstruction