Abstract:In order to improve the stability of α‑AlH3， acidic and organic solutions were used as modifiers to treat α‑AlH3. Through structural characterization， stability test， and mechanical sensitivity test， the properties of samples before and after the treatment were compared and analyzed， and the hydrogen release of α‑AlH3 after modification was discussed. The performance on hydrogen release and the corresponding modification mechanisms were compared， and the modifier with a better stabilizing effect was obtained. The experimental results show that the proposed modification methods are effective and have a negligible effect on the hydrogen release properties of the studied samples. The weight loss associated with hydrogen release observed for the modified α‑AlH3 does not exceed by 1%， and the changes in initial temperature and peak temperature of hydrogen release are less than ±3 ℃， the maximum hydrogen release rate is not affected by more than 20%. Treatment by hydrobromic acid solution exhibited the best effect on enhancing the storage stability of α‑AlH3， and the amount of hydrogen release for the studied samples during the storage was found to decrease from 0.87% to 0.02%. It suggests that the acidic and organic solution treatment can reduce the impurities and defects on the surface of α‑AlH3 sample， and the amorphous alumina or aluminum hydroxide are likely to be formed on the surface of α‑AlH3 after the acidic solution treatment which enhances the stability of α‑AlH3. Compared with organic solutions， the acidic solution treatment shows a better ability to maintain the hydrogen release properties of α‑AlH3， enhance its storage stability， and reduce mechanical sensitivity， which can be used as a promising modifier in practical applications.

The enhanced thermal stability and reduced hygroscopicity of aluminum hydride coated with vinyltrimethoxysilane

Improved Hydrogen Generation from the Hydrolysis of Aluminum Ball Milled with Hydride

Reactivity and stabilization mechanisms of AlH3 crystals by coating of polyvinylidene difluoride

Stability, reactivity and decomposition kinetics of surface passivated α-AlH3 crystals

Directed Stabilization by Air-Milling and Catalyzed Decomposition by Layered Titanium Carbide Toward Low-Temperature and High-Capacity Hydrogen Storage of Aluminum Hydride

Catalytically ultrathin titania coating to enhance energy storage and release of aluminum hydride via atomic layer deposition

Theoretical study on the stability mechanism of a high energy system composed of molecules containing COC or –N3 groups and aluminum hydride

Dehydriding Properties of Ti Or/and Zr-doped Sodium Aluminum Hydride Prepared by Ball-Milling

Microstructure and interaction in aluminum hydrides@polydopamine composites and interfacial improvement with GAP adhesive

Study on Hydrogen Generation from the Hydrolysis of a Ball Milled Aluminum/calcium Hydride Composite

Construct the α-AlH 3 @Polymers Composite with High Safety and Excellent Stability Properties via In-situ Polymerization

Synthesis, Analysis, and Characterization of Aluminum Nanoparticles Coated with 2,2,4-Trimethylpentane

Wet Chemical Synthesis of Non-solvated Rod-Like Α'-Alh3 As a Hydrogen Storage Material.

Dehydriding properties of γ-AlH3

Surface Passivation of Aluminum Hydride Particles Via Atomic Layer Deposition

Advanced preparation and processing techniques for high energy fuel AlH3

Study on the Dehydrogenation Properties and Reversibility of Mg(Bh4)(2)-Alh3 Composite under Moderate Conditions

Stabilizing Modifications ofα?AlH3 by Acidic and Organic Solution Treatment

Improved hydrogen desorption properties of LiBH4 by AlH3 addition

Synthesis and Stability of Hydrogen Storage Material Aluminum Hydride

Enhanced stability and combustion performance of AlH3 in combination with commonly used oxidizers