Abstract:As the high critical current at high field, the representative second-generation high-temperature superconductor (2G HTS) REBCO-coated conductor serves as a good candidate for the future China Fusion Engineering Test Reactor (CFETR) with a magnet field exceeding 15 T. The Institute of Plasma Physics, Chinese Academy of Sciences (ASIPP) is engaged in the R D activities of REBCO-based HTS Twisted Stack Slotted-core Cables (TSSC) with the objective of validating the feasibility of cable-in-conduit conductor (CICC). Two 1.3-m-long TSSC samples, each comprising 32 3-mm-wide REBCO-coated conductors and 56 copper tapes, have been manufactured and successfully tested at 77 K and self-field, followed by a joint resistance test at 4.2 K. The critical current of the both TSSC specimens at 77 K was tested to be 2830–2886 A with an n-value of approximately 30, which is similar to the simulation value, demonstrating no significant degradation occurred during fabrication. Nevertheless, current transfer between cables is carried out through joints, and the manufacturing process of the joint terminals can seriously affect the capability to achieve current transfer with a low resistance. Therefore, an oil-bath heated melting solder method was presented to prepare the joint terminals for HTS TSSC cables, as well as resistance measurements being evaluated. At 77 K, the terminal resistance was measured to be in the tens of nano-ohms, in comparison to about 0.68 nΩ at 4.2 K. The findings of this study offer valuable insight into the conductor preparation process and provide a foundation for future developments in large-scale fusion magnet applications.

Development of 4ka Current Leads Using Stacked REBCO Tapes for BESIII Detector Magnet

Design and Development of 16-Ka HTS Current Lead for HMFL 45-T Magnet

Development of 12 Ka Hts Current Lead for Accelerator Magnet Test Application

Full Power Test of Superconductor of BESIII Magnet

Design, Modification.and Test of the Conduction Cooled High-Current Current Leads for the Superconducting Magnet

Design and experimental research on a new structure of 20 kA ReBCO high temperature superconducting current lead

Design and Testing of a Gas-Helium Conduction Cooled REBCO Magnet for a 300 kvar HTS Synchronous Condenser Prototype

R&D on 52-kA HTS Current Lead at ASIPP

Manufacture and Testing of Pre-prototype HTS Twisted Stack Slotted-Core Cable

Factory Acceptance Test of 50-Ka HTS Current Leads for the ITER CS Magnet Test Application

R&D ON SHUNT FOR HIGH SAFETY HTS CURRENT LEADS FOR ITER

R&D ON A 68 kA HTS CURRENT LEAD FOR ITER PROJECT

Design, Development and Fabrication for BESIII Superconducting Muon Detector Solenoid

Design of Bi-based Superconducting Current Lead for SMES

Experimental Studies of Critical Currents and Joint Resistance of HTS Twisted Stack Slotted-Core Cables

The Operation Test of YBCO Binary Current Leads Developed for an NI REBCO Magnet

A Novel REBCO Conductor Design to Reduce Screening-Current Field in REBCO Magnets

A Novel Aluminum-Stabilized Stacked REBCO Tape Cable

Study on the Arrangement of REBCO Double-Pancake Coils with Different Critical Currents in 30-T Superconducting Magnets

Double-Spiral Current Leads of Bi-2223 Tapes for A Smes Magnet

Experimental study on the an-isotropic critical current of REBCO tape