Abstract:A higher available magnetic field can give more flexibility for significant research and constructions. Inserting feasible high-temperature-superconducting (HTS) magnet inside low-temperature-superconducting (LTS) external is becoming an efficient method to build ultra-high-field (UHF) magnets. However, HTS insert magnets exhibited concentration of magnetic strain during the energization, significantly owing to the screening-current effect. This phenomenon affect the structural integrity of HTS magnets, posing a difficulty for UHF magnets to reach a center field larger than 30 T. In this paper, we report the recent progress of the 35 T all-superconducting UHF magnet project. The full-cycle development of this homemade UHF magnet was a strong collaboration with multiple domestic institutions in China. We used commercial REBa2Cu3O7-x (RE = rare earth element, REBCO) conductors to wind the 20 T HTS insert. Specifically, we optimized the electromagnetic design of this HTS insert with consideration of screening-current induced strain. We applied the no-insulation and metal-as-insulation winding techniques simultaneously to balance the time constant of the two nested REBCO coils. During the excitation test, the HTS insert maintained a 256 A operation current as designed for nearly 18 hours. With the energization of LTS external magnet, the entire facility reached a center field larger than 20 T for 16 hours, 30 T for 6.35 hours and 32 T for 2 hours. It finally reached a 32.4 T center field, at which point the LTS external quenched, inducing the HTS insert to quench as well. After quench, the HTS magnet can maintained 229 A operation current during the postmortem standalone test. This 32.4 T result exhibits effectiveness of considering the screening-current induced strain to enhance the structural integrity of REBCO magnets, and verifies the high reliability of REBCO magnets by generating a long-duration high field environment without any quench accident originating from the REBCO magnet.

Full Power Test of Superconductor of BESIII Magnet

Development of a Conduction-Cooled HTS SMES

Development of 4ka Current Leads Using Stacked REBCO Tapes for BESIII Detector Magnet

Design, Development and Fabrication for BESIII Superconducting Muon Detector Solenoid

Development of Testing Device for Critical Current Measurements for HTS/LTS

Fabrication of Nbti Superconducting Joint by Electromagnetic Forming Method

Design and Test of A Short Mockup Magnet for the Superconducting Undulator at the Ssrf

Self-protected high-temperature superconducting demonstrator magnet for particle detectors

Design and Testing of a Gas-Helium Conduction Cooled REBCO Magnet for a 300 kvar HTS Synchronous Condenser Prototype

Quench Analysis and Improvement of a Semi-Open Split NbTi Superconducting Magnet With Large Inductance

Development of Electromagnetic Forming Nbti Superconducting Joint

Development of YBCO Insert for a 25 T All Superconducting Magnet

Mechanical Design, Assembly and Strain Measurement Results of a 13-T Superconducting Dipole Magnet

First performance test of a 25 T cryogen-free superconducting magnet

Electromagnetic, stress and thermal analysis of the Superconducting Magnet

Fabrication and Test of Nb3Sn-NbTi Superconducting Joint for a 14-T MRI Magnet

33.8 TESLA WITH A YBa2Cu3O7−xSUPERCONDUCTING TEST COIL

Fabrication of Bi-2223 High Temperature Superconducting Magnet

Experimental study on the an-isotropic critical current of REBCO tape

Strain analysis and preliminary test of an all-superconducting high-field magnet generating 32.4 T direct-current magnetic field

Development of Superconducting Magnets and Its Applications in IHEP