Abstract:To explore room-temperature strengthening and high-temperature ductility, a lightweight novel Mg-1.85Gd-0.64Al-0.62Zn alloy was fabricated by innovative multidirectional forging and a hot-rolling technique. Microstructures and mechanical properties were studied at room and elevated temperatures with an optical microscope, an X-ray diffractometer, and a tensile tester. An ultimate tensile strength of 260 MPa, yield strength of 171 MPa, and elongation of 20.4% were demonstrated at room temperature. The room-temperature strengthening mechanisms were identified by strengthening the model estimation. A type C Portevin-Le Chatelier effect was discovered and elucidated in this alloy. X-ray diffraction analysis revealed that the phase composition is α-Mg solid solution and (Mg, Al)3Gd, Al7Zn3, and Al2Gd intermetallic compounds. Examination of the microstructure at elevated temperatures revealed that dynamic recrystallization and dynamic grain growth occur. In particular, it was discovered that bimodal microstructures or incomplete dynamic recrystallization microstructures exist in high-temperature deformation. A maximum quasi-superplasticity of 228.4% was demonstrated in this alloy at 673 K and 5.0 × 10-4 s-1. Flow stress curves showed that the present alloy exhibits Sotoudeh-Bate curves or a long intermediate strain-hardening stage followed by a strain-softening stage. A modified Zerilli-Armstrong constitutive equation incorporating the number of dislocations was established. The power-law constitutive equation was established to identify the deformation mechanism. Both constitutive models had good predictability. At 673 K and 5.0 × 10-4 s-1, the stress exponent was 4, and the average deformation activation energy was 104.42 kJ/mol. The number of dislocations inside a grain was 146. This characteristic evidence confirmed that dislocation motion controlled by pipe diffusion dominates the rate-controlling process under this condition.

Deformation-driven Modification Towards Strength-Ductility Enhancement in Al–Li–Mg–Zn–Cu Lightweight High-Entropy Alloys

Inherent and Multiple Strain Hardening Imparting Synergistic Ultrahigh Strength and Ductility in a Low Stacking Faulted Heterogeneous High-Entropy Alloy

Experimental and DFT Investigations of AlNbTiVZr High Entropy Alloys with Excellent Mechanical Properties

Grain refinement induced dynamic plasticity improvement in lightweight high entropy alloys

Micromechanical origin for the wide range of strength-ductility trade-off in metastable high entropy alloys†

Strength-ductility materials by engineering coherent interface at incoherent precipitates

Enhancement of Strength-Ductility Trade-off in a High-Entropy Alloy Through a Heterogeneous Structure

Improving the ductility of high-strength multiphase NiAl alloys by introducing multiscale high-entropy phases and martensitic transformation

A Low-Cost Lightweight Entropic Alloy with High Strength

Alloying design and microstructural control strategies towards developing Mg alloys with enhanced ductility

Plasticity Improvement in a Co-Rich Co40Fe25Cr20Ni15 High-Entropy Alloy via Al Alloying

Improvement of Mechanical Behaviors of a Superlight Mg-Li Base Alloy by Duplex Phases and Fine Precipitates

Achieving exceptional strength-ductility synergy in a dual-phase high entropy alloy via architected complex microstructures

Room-Temperature Strengthening, Portevin-Le Chatelier Effect, High-Temperature Tensile Deformation Behavior, and Constitutive Modeling in a Lightweight Mg-Gd-Al-Zn Alloy

Strain Hardening Behavior of Ti-Rich Light-Weight Medium Entropy Alloys with Excellent Strength and Plasticity Synergy

Breaking the Strength-Ductility Trade-off Via Heterogeneous Structure in FeCoCrNiMo0.2 High-Entropy Alloy

Enhanced strength and ductility synergy of a CoCrFeMnNi high entropy alloy with a hierarchical structure via severe distortion

High specific yield strength TiZrAlNbV high-entropy alloys via coherent nanoprecipitation strengthening

Substitutional and Interstitial Atoms Co-Doping Overcomes the Strength–ductility Trade-off in Lightweight Refractory Medium-Entropy Alloys

Investigation of the Micromechanical Behavior of a Ti68Nb7Ta3Zr4Mo18 (at.%) High-Entropy Alloy

Strength-ductility Synergy of Al-bearing Low-Density Refractory TiNbMo0.5AlX Medium Entropy Alloys Via Precipitation