Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

A Warped-Cantilever MEMS MOS Gas Sensor Array

A Low Power Cantilever-Based Metal Oxide Semiconductor Gas Sensor

From Ceramic Tube to Microcantilever: A New Strategy for Low Power, Fast Heating and High Integrated Metal Oxide Semiconductor Gas Sensor

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

A Low Power 4-Channel Single-Cantilever Metal-Oxide Gas Sensor Cell with Gas Identification Capability

Monolithic Integrated Cmos-Mems Mos Type Gas Sensor And Novel Heater For Sensitivity And Power Consumption Enhancement

A Single Microcantilever-Type Gas Sensor with Enhanced Sensitivity to Ethanol by Sputtering ZnO with Au Embedded in O2 Atmosphere

Design and Experimentation with Sandwich Microstructure for Catalytic Combustion-Type Gas Sensors

Non-Silicon MEMS Calorimetric Gas Flow Sensor

Design and Fabrication of MOS Type Gas Sensor with Vertically Integrated Heater Using CMOS-MEMS Technology

Design and Simulation of an Ultra-Low-Power Hydrogen Sulfide Gas Sensor with a Cantilever Structure

A Low Power Four-Channel Metal Oxide Semiconductor Gas Sensor Array With T-Shaped Structure

A Fully Integrated Gas Detection System With Programmable Heating Voltage and Digital Output Rate for Gas Sensor Array

Chemical Sensors Based on Piezoresistive Cantilever Array

Direct Bonding SOI Wafer Based MEMS Cantilever Resonator for Trace Gas Sensor Applicaiton

A Smart Resonating Micro-Cantilever in MEMS Gas Sensor: Improved Design

Thermally-Excited MEMS Cantilever Resonator for Gas Sensing

Design and Implementation of Multi-Layer Opened-IDAs Electrodes for the Response Enhancement of CMOS-MEMS Gas Sensors at Room Temperature

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology