Abstract:Polyethylene (PE) occupies a large proportion in waste plastics, while its natural degradation rate is slow, if without timely recycling treatment, which would directly lead to serious ecological and environmental problems. Incineration and thermolysis methods based on thermochemical conversion are commonly used effective ways for the treatment of plastic waste, which presented the advantages of high efficiency and low pollution. In this paper, cone calorimeter and tubular thermolysis furnace-mass spectrometer (MS) combination platform were applied for the catalytical combustion and thermolysis characteristics of PE with three kinds of catalysts, which were H-Zeolite Standard Oil Corporation Of New York (Socony) Mobil-Five (HZSM-5), H-ultra stable Y zeolite (HUSY), and Mobil Composition of Matters-41 (MCM-41), respectively. Under the effect of MCM-41, the heat release rate (HRR) of samples under different heat flux (25, 35, 45 kW/m2) was decreased by 59.7%, 48.8%, and 46.6%, and the time to peak HRR was advanced in 60 s, 27 s, and 10 s, respectively. Therefore, the burning efficiency could be controlled and the fire risk would be declined with the addition of catalysts. With the increase of the catalyst pore diameter, the combustion efficiency was enhanced, while rising incineration temperature would not necessarily mean an increase in combustion efficiency. During thermolysis, HZSM-5 was most effective catalyst for the conversion of PE to alkenes and aromatic hydrocarbons (AHs) such as benzene, toluene, and xylene (BTX). Among the three catalysts, the microporous HZSM-5 showed higher catalytic performance due to its strong acidity and suitable pore structure. This work enriches the combustion and thermolysis mechanism of PE, and provides reference and basis for the design of waste plastic recycling processing.Graphical abstractThe catalytic incineration and pyrolysis of polyethylene were investigated, which might provide reference for the waste plastic recycling processing design.

Dielectric Barrier Discharge Plasma Synergistic Catalytic Pyrolysis of Waste Polyethylene into Aromatics-Enriched Oil

Mechanistic Understanding of Efficient Polyethylene Hydrocracking over Two-Dimensional Platinum-Anchored Tungsten Trioxide.

Pyrolysis of Polyolefins Using Rotating Arc Plasma Technology for Production of Acetylene

Catalytic pyrolysis of waste polyethylene into benzene, toluene, ethylbenzene and xylene (BTEX)-enriched oil with dielectric barrier discharge reactor

Catalytic Pyrolysis of Waste Polyethylene into Aromatics by H3PO4-Activated Carbon

Polyethylene upcycling to aromatics by pulse pressurized catalytic pyrolysis

Hydrogen-free Upcycling of Polyethylene Waste to Methylated Aromatics over Ni/ZSM-5 under Mild Conditions.

Co-hydropyrolysis of Pine and HDPE over Bimetallic Catalysts: Efficient BTEX Production and Process Mechanism Analysis

Sustainable production of aromatics via catalytic pyrolysis of polyolefins towards the carbon cycle for plastics

Mechanism of synergistic effects and kinetic analysis in bamboo-LDPE waste <i>ex</i>-<i>situ</i> catalytic co-pyrolysis for enhanced aromatic hydrocarbon production via CeZrAl and HZSM-5 dual catalyst

Mechanism of synergistic effects and kinetic analysis in bamboo-LDPE waste ex-situ catalytic co-pyrolysis for enhanced aromatic hydrocarbon production via CeZrAl and HZSM-5 dual catalyst

Hydrogen and aromatics recovery through plasma-catalytic pyrolysis of waste polypropylene

Characteristics of Pyrolyzing Polyethylene in a Horizontal Plasma Jet Reactor

One-Pot Upgrading Polyethylene and CO 2 to Aromatics Via Tandem Catalysis

Efficient Pyrolysis of Low-Density Polyethylene for Regulatable Oil and Gas Products by ZSM-5, HY and MCM-41 Catalysts

Catalytic Pyrolysis of Waste Polyethylene Using Combined CaO and Ga/ZSM-5 Catalysts for High Value-Added Aromatics Production

Microwave-assisted pyrolysis of low-density polyethylene (LDPE)to value-added products over HY, HZSM-5 and Hβ catalyst

Pyrolysis behavior of low-density polyethylene over HZSM-5 via rapid infrared heating

Catalytic Co-Pyrolysis of Polycarbonate and Polyethylene/polypropylene Mixtures: Promotion of Oil Deoxygenation and Aromatic Hydrocarbon Formation

Enhancement of catalytic combustion and thermolysis for treating polyethylene plastic waste

Effect of ZnCl 2 -activated biochar on catalytic pyrolysis of mixed waste plastics for producing aromatic-enriched oil.