Abstract:Polyethylene (PE) occupies a large proportion in waste plastics, while its natural degradation rate is slow, if without timely recycling treatment, which would directly lead to serious ecological and environmental problems. Incineration and thermolysis methods based on thermochemical conversion are commonly used effective ways for the treatment of plastic waste, which presented the advantages of high efficiency and low pollution. In this paper, cone calorimeter and tubular thermolysis furnace-mass spectrometer (MS) combination platform were applied for the catalytical combustion and thermolysis characteristics of PE with three kinds of catalysts, which were H-Zeolite Standard Oil Corporation Of New York (Socony) Mobil-Five (HZSM-5), H-ultra stable Y zeolite (HUSY), and Mobil Composition of Matters-41 (MCM-41), respectively. Under the effect of MCM-41, the heat release rate (HRR) of samples under different heat flux (25, 35, 45 kW/m2) was decreased by 59.7%, 48.8%, and 46.6%, and the time to peak HRR was advanced in 60 s, 27 s, and 10 s, respectively. Therefore, the burning efficiency could be controlled and the fire risk would be declined with the addition of catalysts. With the increase of the catalyst pore diameter, the combustion efficiency was enhanced, while rising incineration temperature would not necessarily mean an increase in combustion efficiency. During thermolysis, HZSM-5 was most effective catalyst for the conversion of PE to alkenes and aromatic hydrocarbons (AHs) such as benzene, toluene, and xylene (BTX). Among the three catalysts, the microporous HZSM-5 showed higher catalytic performance due to its strong acidity and suitable pore structure. This work enriches the combustion and thermolysis mechanism of PE, and provides reference and basis for the design of waste plastic recycling processing.Graphical abstractThe catalytic incineration and pyrolysis of polyethylene were investigated, which might provide reference for the waste plastic recycling processing design.

Characteristics of Pyrolyzing Polyethylene in a Horizontal Plasma Jet Reactor

Pyrolysis of Polyolefins Using Rotating Arc Plasma Technology for Production of Acetylene

Analysis on low-temperature polyethylene pyrolysis and gasification in different atmospheres

Gas Production from Polyethylene Terephthalate Using Rotating Arc Plasma

Hydropyrolysis of N-Hexane and Toluene to Acetylene in Rotating-Arc Plasma

Gasification Performance of Cellulose in Horizontal Plasma Jet Reactor

Investigating Kinetic Behavior and Reaction Mechanism on Autothermal Pyrolysis of Polyethylene Plastic

Molecular Dynamics Simulation of Converting Waste Polyethylene (PE) to Chemicals and Fuels under Non-Isothermal and Isothermal Conditions

Fluidized Bed Gasification of PE Plastic in Municipal Solid Waste

Dielectric Barrier Discharge Plasma Synergistic Catalytic Pyrolysis of Waste Polyethylene into Aromatics-Enriched Oil

Process Development and Reactor Analysis of Coal Pyrolysis to Acetylene in Hydrogen Plasma Reactor

Production of hydrogen-rich fuel gas from waste plastics using continuous plasma pyrolysis reactor

Analysis of polyethylene pyrolysis using a bench scale fixed bed

Characteristics of a new type continuous two-stage pyrolysis of waste polyethylene

Enhancement of catalytic combustion and thermolysis for treating polyethylene plastic waste

Experimental Study on Coal Pyrolysis to Acetylene in Thermal Plasma Reactors

Thermodynamic analysis of coal pyrolysis to acetylene in hydrogen plasma reactor

Experimental Study of Polyethylene Pyrolysis and Combustion over HZSM-5, HUSY, and MCM-41.

Fast pyrolysis of biomass and waste plastic in a fluidized bed reactor

Catalytic Pyrolysis of Polyethylene and Polypropylene Over Y Zeolite

Pyrolysis characteristics of organic components of municipal solid waste at high heating rates.