Abstract:A concept of incorporating aligned multi-walled carbon nanotubes (MWCNTs) in the adhesive layer has been demonstrated to enhance the through-thickness thermal conductivity in the adhesively bonded joints. Both numerical and experimental studies were performed to determine key components in improving the through-thickness thermal conductivity and to realize the improvement in an adhesively-jointed system. The numerical analysis indicated that the key components to improve the through-thickness thermal conductivity in the adhesive joints are using highly conductive vertically aligned nanotubes as well as the thermal conductivity and the size of a transition zone between the nanotube ends and surrounding matrix materials in the form of either the adhesive or adherends. Therefore, the thermal contact of the conductive phase (the MWNT in this case) with the adherent surfaces is essential to achieve the desirable through-thickness thermal conductivity in joints. This theoretical observation was demonstrated experimentally by using conductive graphite facesheets as adherends and the polymer adhesive layer with the aligned MWCNTs. To ensure the ends of the MWCNTs make thermal contact with the adherent surfaces, the surface of the adhesive with the MWCNTs were plasma-etched and coated with thin Au layer, along with the surface of the graphite facesheet coated with thin Au–Pd layer. The measured value of the through-thickness thermal conductivity of the modified adhesive joint with the MWNCT was over 250W/mK, which superseded the thermal conductivity of neat adhesive joint by several order of magnitudes. Thus the study demonstrates a new approach as well as opportunities of much needed thermal property tailoring in structural joints.

Experimental and Numerical Investigation of T‐joints with Multiwalled Carbon Nanotubes

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

Influence of Inter-tube Connections on the Stress-Strain Behavior of Nanotube-Polymer Composites: Molecular Dynamics

Reducing Dispersity of Mechanical Properties of Carbon Fiber/epoxy Composites by Introducing Multi-Walled Carbon Nanotubes

Interfacial Strengthening and Self-Monitoring in Carbon Fiber-Reinforced Composites via Carbon Nanotube-Based Damage Sensors

Strengthening of Composite T-joints Using Ø 0.11 Mm Z-pins Via an Ultrasound-Guided Insertion Process

Aminated carbon nanotube enhanced composite T‐joints mediating CFRP load‐bearing capacity improvement

Abstract: Influencing Plastic Surgery Patient Experience: Factors Affecting Patient Satisfaction Surveys

Investigating the Effects of Contact Area and Chamfering on the Failure Behavior of Plain Woven Composite-Metal T-joints

A CNT-Toughened Strategy for In-Situ Repair of Aircraft Composite Structures

Characterization of the interface and interphase region in the multi-walled carbon nanotube modified epoxy resin/carbon fiber hybrid nanocomposite

Experimental study on physical and mechanical properties and micro mechanism of carbon nanotubes cement-based composites

Optimization of the mechanical properties of CNTs/Cu composite by regulating the size of interfacial TiC

A nanomodified-ultrasonic method to improve the shear strength of adhesively bonded composite joints

The effect of MWCNTs with different diameters on the interface properties of Ti/CFRP fiber metal laminates

Compressive Strength and Microstructure of Multi-Wall Carbon Nanotubes Reinforced Cement Composites

Enhancement of load transfer by interfacial bonding in Al-Cu-Mg joints under the in-situ synergistic effect of carbon nanotubes and silicon nitride

Enhancement of through-thickness thermal conductivity in adhesively bonded joints using aligned carbon nanotubes

Interface enhancement of carbon nanotube/mesocarbon microbead isotropic composites

Synergistic enhancement effect of flame-grown carbon nanotubes and chopped carbon fibers on adhesive joint of thermosetting laminate

Reinforcing Adhesives Using Carbon Nanotubes for the Carbon Fibre Reinforced Plastic Composite and Metal Joint