Abstract:Multi-channel wire electrical discharge machining (WEDM) is widely used for slicing semiconductor materials and improving cutting rate through multi-channel discharge. However, enhancing the cutting rate of integral metal workpieces through the utilization of multi-channel WEDM remains a challenge. This paper investigated the discharge characteristics of metal workpiece using multi-channel high-speed WEDM (HSWEDM). It was discovered that due to the high conductivity of the metal workpiece, there is electrical signal coupling between each channel, which inhibits the independent discharge of each channel and severely impacts the improvement of cutting rate. To solve this problem, a new power supply with a decoupled circuit was designed, and the potential difference between adjacent channels was formed by using a current-limited resistor at each output, reducing coupling between the channels and enabling independent discharges at each channel, thereby improving the cutting rate of metal materials. The effect of current-limited resistance ( R c ) on multi-channel synchronous discharges was analyzed through online acquisition of discharge signals, demonstrating that reducing the R c can improve the discharge ratio. In the two-channel HSWEDM with the new power supply, when the R c is reduced from 15 to 5/3 Ω, the gap voltage is increased from 31 to 64 V, the discharge ratio is increased from 0.967 to 1.566, and the increase in cutting rate was from 19.06% to 83.02%. Furthermore, when R c is 5/2 Ω, the cutting rate was 1.660–1.971 times that of conventional power supply. Since each channel can implement independent servo control after electrical signal decoupling, the dimensional uniformity and surface topography of grooves are improved, and the thickness of the recast layer is reduced. Lastly, the new power supply was applied to the four-channel HSWEDM, resulting in a significant increase in cutting rate, which was 3.538 times higher than that of conventional power supply.

Improving RT-WEDM Performance with a Radio Frequency Signal Monitoring System

Monitoring Technology Of Gap Discharge Status Based On Floating Threshold For Wedm

Study on Adaptive Servo Control Strategy of WEDM Based on Discharge State Detector

Improving performance of micro-hole EDM based on frequency detection method

Research on a two-stage discharge current regulation method in RT-WEDM

Pulsed Power Supply Superposed With Radio Frequency Oscillating Wave for the Improvement of Micro-Electrical Discharge Machining Process

Monitoring Of Edm Gap Discharge Status With Wavelet Transform Method

Pulsed Power Supply Superposed with RF Oscillating Wave for the Improvement of Micro EDM Process

Study on Machining Characteristics of WEDM with Ultrasonic Vibration and Magnetic Field Assisted Techniques

A Discharge Pulse Discrimination Strategy for High Speed WEDM with Power-Electronic-based Pulse Power Generator

Gap status identification and control of wire electrochemical micromachining

Study on discharge characteristics and process of multi-channel high-speed wire electrical discharge machining for metal workpieces

Detecting Discharge Status of Small-Hole EDM Based on Wavelet Transform

On-line Monitoring of WEDM-LS Surface Roughness Byutilizing Time-Frequency Characteristics of AE Signal

Improvement of the Machining Characteristics in WEDM Based on Specific Discharge Energy and Magnetic Field–assisted Method

Experimental Study on Energy Consumption of Energy-Saving Pulse Power for WEDM

A discharge plasma regulation method with spike current for electrical discharge machining

Study on the Servo Control System of MWEDM

A new high-speed observation system for evaluating the spark location in WEDM of Inconel 718

Development and Experimental Study of MWEDM Prototype

Experimental study of MWEDM technology