Abstract:Time series data of gap state were often used as feedback signal in EDM control systems. An effective way to quantify gap state in machining was developed in this paper. Based on a time series of gap states recording a machining process, the entire process was partitioned into three parts, transient process, efficient machining process, and deleterious process. It is expected that efficient machining process should be maintained long enough in consideration of machining efficiency and avoiding workpiece surface damage. In this case, a signature of structural change from efficient machining process to deleterious process has to be detected or detected in advance. It has been found that linear analysis methods failed the task. In this paper, a nonlinear analysis method, cross-prediction error, was employed to track this structural change in efficient machining process in two tests. In the first test, the efficient machining process was roughly split into 30 segments. By using the cross-prediction-error method in this test, the non-stationarity, a signature of structural change from stationary process in efficient machining process to non-stationary process, was successfully revealed in the last segment of the process. In another test, efficient machining process was even more finely split into 70 segments, and by using the cross-prediction-error method again it is found that the detected non-stationarity in the process was in the last segment but one. The second test not only proves the effectiveness of the method, but also brings forward the detected non-stationarity more than 10s. The detected non-stationarity in advance, thus, is supposed to be used for avoiding the occurrence of abnormal deleterious process and maintaining a persisted efficient machining process.

Monitoring Of Edm Gap Discharge Status With Wavelet Transform Method

A Denoise Method of Electrical Discharge Machining Gaps Signal for Non-Conductive Engineering Ceramics Based on Wavelet Mma

Grinding wheel wear monitoring based on wavelet analysis and support vector machine

Gap status identification and control of wire electrochemical micromachining

Analysis and control of electrical discharge machining (EDM) process

Assessment of the Dynamical Properties in EDM Process—detecting Deterministic Nonlinearity of EDM Process

Development of an On-Line Defect Detection System for EDM Process

A time-varied predictive model for EDM process

Assessment of Dynamical Properties in EDM Process—detecting Signature of Latent Change to Deleterious Process in Advance

Performance monitoring and failure prediction system for wire electric discharge machining process through multiple sensor signals

On-line Monitoring of WEDM-LS Surface Roughness Byutilizing Time-Frequency Characteristics of AE Signal

The Methodology Of Detecting Dynamical Properties Of Electrical Discharge Machining (Edm) Process Towards Building A Timely Varied Linear Predictive Model

Application of Wavelet on Retaining the Shape of Partial Discharge Pulse of Power Cables

Wavelet transform applying in partial discharge measurement

A Method of Hole Pass-Through Evaluation for EDM Drilling

Simulation and experimentation of renewable dielectric gap flow fields in EDM

Gap Measurement of Point Machine Using Adaptive Wavelet Threshold and Mathematical Morphology

Study of Alternating Current Flow in Micro-Edm Through Real-Time Pulse Counting

Hybrid Control of Discharging State During EDM

Feasibility Research on Break-out Detection Using Audio Signal in Drilling Film Cooling Holes by EDM

A Grinding Acoustic Emission Monitoring Method Using Wavelet Transforms and Fuzzy Logic