Abstract:Electrical discharge machining (EDM) is frequently employed in micropore machining of difficult-to-cut materials as a result of the contactless characteristics. However, debris produced by electrode discharge ablation of the workpiece tends to accumulate at the bottom of the hole and is difficult to discharge, resulting in abnormal discharge, which reduces processing efficiency and increases electrode loss. These issues can be resolved with the introduction of ultrasonic-assisted technology, but since it is difficult to obviously observe micro phenomena like bubble rupture, fluid movement, and debris movement, there has been little real-situation study on fluid environments. In this study, first, mathematical models of the improvement of ultrasonic-assisted discharge energy and erosion efficiency were developed. Then, the ultrasound-assisted electrical discharge machining (UEDM) process was simulated on the basis of gas–liquid-solid three-phase fluid coupling analysis to investigate the influence law of the ultrasonic cavitation effect and pumping effect on fluid movement and debris movement. Then, the comparative test of EDM and UEDM in machining titanium alloy plate was carried out to explore the impact of ultrasonic-assisted technology on the level of single process parameters, taking the processing time, electrode loss, and hole taper as indicators, respectively. Finally, multi-objective particle swarm optimization (MOPSO) was used to obtain the optimal parameter group of EDM and UEDM, and this parameter group was used for drilling test to examine the effects of ultrasonic-assisted technology on the process parameter level. According to the research, the fluid stability is destroyed by the effects of ultrasonic cavitation and pumping, which also increase the local fluid speed by a hundred times and encourage the discharge of debris, thereby reducing the processing time, lowering electrode loss, lowering hole taper, and improving the surface quality of micropores.

Hybrid Control of Discharging State During EDM

Study of Adaptive Control System for EDM Process

The Research On The Self Adaptive Fuzzy Control System For Electric Discharge Machining

Improvement of EDM efficiency with a new adaptive control strategy

Adaptive Control for EDM Process with a Self-Tuning Regulator

The Research On The Neuro-Fuzzy Network Control Strategy For Electric Discharge Machining Process

Research on Intelligent Controller for Edm Online Parameters

Analysis and control of electrical discharge machining (EDM) process

A Distributed Model Predictive Control Algorithm with the Gap Metric Output Feedback Decoupling

Research of Electric Discharge Machining Approach Based on Intellectual Control

Sliding-mode Controller and Algorithm for Improving Servo Control of Discharge Gap in Precise Fast Hole EDM

Research on the Efficient Self-Adaptive Servo-Control Strategy in Micro-Edm Milling

Optimized Control of Electrical Discharge Machining Driven by Linear Motor

A Study of Influence of Servo-Control Strategy on Machining Efficiency in Micro-EDM

Assessment of the Dynamical Properties in EDM Process—detecting Deterministic Nonlinearity of EDM Process

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode

Adaptive control of discharge parameters for EDM of thermal barrier coated superalloys

Gap status identification and control of wire electrochemical micromachining

A time-varied predictive model for EDM process

Improvement of ultrasonic cavitation and pumping effect in microhole EDM

Servo Control Optimization of Micro Discharge Gap and Its Reasonable Matching with Scanning Speed in Servo Scanning 3D Micro EDM Based on Threshold Control Method