Abstract:Time series data of gap state were often used as feedback signal in EDM control systems. An effective way to quantify gap state in machining was developed in this paper. Based on a time series of gap states recording a machining process, the entire process was partitioned into three parts, transient process, efficient machining process, and deleterious process. It is expected that efficient machining process should be maintained long enough in consideration of machining efficiency and avoiding workpiece surface damage. In this case, a signature of structural change from efficient machining process to deleterious process has to be detected or detected in advance. It has been found that linear analysis methods failed the task. In this paper, a nonlinear analysis method, cross-prediction error, was employed to track this structural change in efficient machining process in two tests. In the first test, the efficient machining process was roughly split into 30 segments. By using the cross-prediction-error method in this test, the non-stationarity, a signature of structural change from stationary process in efficient machining process to non-stationary process, was successfully revealed in the last segment of the process. In another test, efficient machining process was even more finely split into 70 segments, and by using the cross-prediction-error method again it is found that the detected non-stationarity in the process was in the last segment but one. The second test not only proves the effectiveness of the method, but also brings forward the detected non-stationarity more than 10s. The detected non-stationarity in advance, thus, is supposed to be used for avoiding the occurrence of abnormal deleterious process and maintaining a persisted efficient machining process.

Study of Adaptive Control System for EDM Process

Adaptive Control for EDM Process with a Self-Tuning Regulator

The Research On The Self Adaptive Fuzzy Control System For Electric Discharge Machining

The Research On The Neuro-Fuzzy Network Control Strategy For Electric Discharge Machining Process

Improvement of EDM efficiency with a new adaptive control strategy

Research on Intelligent Controller for Edm Online Parameters

Hybrid Control of Discharging State During EDM

Analysis and control of electrical discharge machining (EDM) process

An Engineering-Effective Adaptive Model Algorithm Control (AMAC) and Simulation

Research of Electric Discharge Machining Approach Based on Intellectual Control

Research on the Efficient Self-Adaptive Servo-Control Strategy in Micro-Edm Milling

A Study of Influence of Servo-Control Strategy on Machining Efficiency in Micro-EDM

Assessment of the Dynamical Properties in EDM Process—detecting Deterministic Nonlinearity of EDM Process

A time-varied predictive model for EDM process

Advanced Electric Discharge Machining of Stainless Steels: Assessment of the State of the Art, Gaps and Future Prospect

Analysis of the Algorithm on Searching for the Optimal Electrode Machining Time in EDM

Sliding-mode Controller and Algorithm for Improving Servo Control of Discharge Gap in Precise Fast Hole EDM

Self-adaptive fuzzy controller with formulary rule for servo control of discharge gap in Micro EDM

EDM Electrode Design and Analysis to Enhance Process Performance

Assessment of Dynamical Properties in EDM Process—detecting Signature of Latent Change to Deleterious Process in Advance

Performance capabilities of EDM of high carbon high chromium steel with copper and brass electrodes