Abstract:Time series data of gap state were often used as feedback signal in EDM control systems. An effective way to quantify gap state in machining was developed in this paper. Based on a time series of gap states recording a machining process, the entire process was partitioned into three parts, transient process, efficient machining process, and deleterious process. It is expected that efficient machining process should be maintained long enough in consideration of machining efficiency and avoiding workpiece surface damage. In this case, a signature of structural change from efficient machining process to deleterious process has to be detected or detected in advance. It has been found that linear analysis methods failed the task. In this paper, a nonlinear analysis method, cross-prediction error, was employed to track this structural change in efficient machining process in two tests. In the first test, the efficient machining process was roughly split into 30 segments. By using the cross-prediction-error method in this test, the non-stationarity, a signature of structural change from stationary process in efficient machining process to non-stationary process, was successfully revealed in the last segment of the process. In another test, efficient machining process was even more finely split into 70 segments, and by using the cross-prediction-error method again it is found that the detected non-stationarity in the process was in the last segment but one. The second test not only proves the effectiveness of the method, but also brings forward the detected non-stationarity more than 10s. The detected non-stationarity in advance, thus, is supposed to be used for avoiding the occurrence of abnormal deleterious process and maintaining a persisted efficient machining process.

Analysis and control of electrical discharge machining (EDM) process

The Methodology Of Detecting Dynamical Properties Of Electrical Discharge Machining (Edm) Process Towards Building A Timely Varied Linear Predictive Model

Assessment of the Dynamical Properties in EDM Process—detecting Deterministic Nonlinearity of EDM Process

The Research On The Self Adaptive Fuzzy Control System For Electric Discharge Machining

The Research On The Neuro-Fuzzy Network Control Strategy For Electric Discharge Machining Process

Adaptive Control for EDM Process with a Self-Tuning Regulator

Study of Adaptive Control System for EDM Process

A time-varied predictive model for EDM process

Research of Electric Discharge Machining Approach Based on Intellectual Control

Assessment of Dynamical Properties in EDM Process—detecting Signature of Latent Change to Deleterious Process in Advance

Towards Creation of a Time-varying Linear Predictive Model

Non-linear Mechanism in Electrical Discharge Machining Process

The Existence of Autonomous Chaos in EDM Process

The Research On The Ga-Based Neuro-Predictive Control Strategy For Electric Discharge Machining Process

Hybrid Control of Discharging State During EDM

EDM Electrode Design and Analysis to Enhance Process Performance

Improving performance of micro-hole EDM based on frequency detection method

Progress in modeling of electrical discharge machining process

A Real-Time Predictive Control Method of Discharge State for Micro-Edm Based on Calamities Grey Prediction Theory

Analyzing of Discharge Wave Oscillation Mechanism in Electrical Discharge Machining

Performance capabilities of EDM of high carbon high chromium steel with copper and brass electrodes