Abstract:Electrical discharge machining (EDM) is frequently employed in micropore machining of difficult-to-cut materials as a result of the contactless characteristics. However, debris produced by electrode discharge ablation of the workpiece tends to accumulate at the bottom of the hole and is difficult to discharge, resulting in abnormal discharge, which reduces processing efficiency and increases electrode loss. These issues can be resolved with the introduction of ultrasonic-assisted technology, but since it is difficult to obviously observe micro phenomena like bubble rupture, fluid movement, and debris movement, there has been little real-situation study on fluid environments. In this study, first, mathematical models of the improvement of ultrasonic-assisted discharge energy and erosion efficiency were developed. Then, the ultrasound-assisted electrical discharge machining (UEDM) process was simulated on the basis of gas–liquid-solid three-phase fluid coupling analysis to investigate the influence law of the ultrasonic cavitation effect and pumping effect on fluid movement and debris movement. Then, the comparative test of EDM and UEDM in machining titanium alloy plate was carried out to explore the impact of ultrasonic-assisted technology on the level of single process parameters, taking the processing time, electrode loss, and hole taper as indicators, respectively. Finally, multi-objective particle swarm optimization (MOPSO) was used to obtain the optimal parameter group of EDM and UEDM, and this parameter group was used for drilling test to examine the effects of ultrasonic-assisted technology on the process parameter level. According to the research, the fluid stability is destroyed by the effects of ultrasonic cavitation and pumping, which also increase the local fluid speed by a hundred times and encourage the discharge of debris, thereby reducing the processing time, lowering electrode loss, lowering hole taper, and improving the surface quality of micropores.

Improvement of EDM efficiency with a new adaptive control strategy

Study of Adaptive Control System for EDM Process

The Research On The Self Adaptive Fuzzy Control System For Electric Discharge Machining

Adaptive Control for EDM Process with a Self-Tuning Regulator

Research on Intelligent Controller for Edm Online Parameters

The Research On The Neuro-Fuzzy Network Control Strategy For Electric Discharge Machining Process

Hybrid Control of Discharging State During EDM

Research on the Efficient Self-Adaptive Servo-Control Strategy in Micro-Edm Milling

A Study of Influence of Servo-Control Strategy on Machining Efficiency in Micro-EDM

Design and Adaptive Terminal Sliding Mode Control of a Fast Tool Servo System for Diamond Machining of Freeform Surfaces

Improvement of machining accuracy by fuzzy logic at corner parts for wire-EDM

Research of Electric Discharge Machining Approach Based on Intellectual Control

Analysis of the Algorithm on Searching for the Optimal Electrode Machining Time in EDM

Sliding-mode Controller and Algorithm for Improving Servo Control of Discharge Gap in Precise Fast Hole EDM

Self-adaptive fuzzy controller with formulary rule for servo control of discharge gap in Micro EDM

Optimization of EDM process parameters based on variable-fidelity surrogate model

Analysis on the Influence of Electrode Jump Height and Speed for Machining Stability in EDM

Research on influence rules of electrode machining time on EDM efficiency

Analysis and control of electrical discharge machining (EDM) process

Improvement of ultrasonic cavitation and pumping effect in microhole EDM

Development and Experimental Research on Sinking Electro-discharge Machining Numerical Control System