Abstract:Micro-EDM is an unconventional technology used to machine every type of electrically conductive material regardless of its mechanical properties. Material removal occurs through electrical discharges between the workpiece and the electrode immersed in a dielectric fluid. In drilling operations, the technology is able to realise microholes with excellent quality in terms of precision, quality surface, roundness, and taper to the detriment of the machining time, which is less than other technologies. Several efforts are being made to improve different features related to the process performance that are severely affected by both the operative conditions, such as the electrode material or the type of dielectric, and process parameters. The typical indexes used to characterise the performance are the machining time, the material removal rate, and the geometric indexes. These indexes are very effective and are easily measurable, but they do not give information about the evolution of the drilling process, which could be irregular due to the different phenomena occurring during machining. The aim of this paper is the development of a method able to elaborate the motion law of the electrode during the micro-EDM drilling operation. In order to do this, a single hole was manufactured in several steps, recording both the machining time and electrode wear for each step. In this way, the actual position of the electrode during the drilling can be measured without the use of a predictive model for electrode wear. It was tested to confirm that the multistep procedure did not introduce new phenomena, in contrast to the traditional drilling operation. This method was used to study the effects of the electrode diameter, the type of electrode, the length of the electrode out of the spindle, and the entity of the run-out on the process performance. The tests were executed on titanium alloy sheets using a tungsten carbide electrode and hydrocarbon oil as the dielectric. It was found that the descent of the electrode into the workpiece was not regular, but it depended on the level of debris concentration in the machining zone. The debris concentration was influenced by the type and diameter of the electrode, its length out of the spindle, and, to a lesser extent, the run-out. This method was found to be a useful method for an in-depth analysis of the micro-EDM drilling process, contributing to a better understanding of the physical aspects of the process.

Study of Alternating Current Flow in Micro-Edm Through Real-Time Pulse Counting

An Analysis of the Uneven Tool Electrode Wear Mechanism in the Micro-electrical Discharge Machining Process

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode

An Investigation into Accumulative Difference Mechanism in Time and Space for Material Removal in Micro-EDM Milling

Influence of superimposed pulse position in superimposed pulse current waveform on surface integrity in electrical discharge machining

Study on characteristics of EDM using pulse power supply with active high-frequency oscillation

A High Energy Density Pulsed Power Supply for Micro EDM of High Aspect Ratio Holes

Investigation of the Material Removal Mechanism in Electrochemical Discharge Drilling Using a High-Speed Rotating Helical Tool-Electrode

A discharge plasma regulation method with spike current for electrical discharge machining

EDM Electrode Design and Analysis to Enhance Process Performance

Study of the Law Motion of the Micro-EDM Drilling Process

Influence of Discharge Current on Machined Surfaces by Thermo-Analysis in Finish Cut of WEDM

Experimental investigations on the influence of discharge current waveform on processing characteristics and surface integrity in electrical discharge machining

Influence of Discharge Current Waveform on Surface Metamorphic Layer in Electrical Discharge Machining

Research on a two-stage discharge current regulation method in RT-WEDM

How the Electrical Conductivity of Water Fluids Affects Micro-EDM in the Short-Pulse Regime

Pulsed Power Supply Superposed With Radio Frequency Oscillating Wave for the Improvement of Micro-Electrical Discharge Machining Process

Wear mechanism and preventive method of silicon electrodes in micro ECM

Short-circuit Avoidance in Electrochemical Machining Based on Polarization Voltage During Pulse off Time

Effects of non-electrical parameters on the characteristics of discharge craters and machining performance in short electrical arc milling

Pulsed Power Supply Superposed with RF Oscillating Wave for the Improvement of Micro EDM Process