Abstract:The effectiveness of Carbon Fiber Reinforced Polymer (CFRP) seismic-retrofit of circular Reinforced Concrete (RC) bridge piers under vehicular lateral impact loading is addressed in the present work performing experimental tests. Sixteen 1/3 scale RC bridge piers with circular cross-sections characterized by three different configurations of longitudinal and transverse reinforcements were tested with and without CFRP seismic-retrofit. In the first case, tested columns represent common shear-deficient RC bridge piers designed with obsolete design practice or for non-seismic areas. In the second case, CFRP wrapping is applied according to common seismicretrofit practices to increase the shear capacity and ductility of columns. Experimental tests were carried out under static and lateral impact loading with propped cantilever conditions reproducing a typical short-span viaduct bridge pier configuration. In the static tests, the lateral load was applied monotonically through a hydraulic jacket under equivalent impact conditions. In impact tests, the lateral impact load was applied through a colliding truck equipped with a rigid hammer at the typical vehicular impact location adopting two different impact velocities (3 and 4.5 m/s). A critical investigation of the transient dynamic characteristics, damage evolution, and post-impact damage is conducted by comparing the results obtained with and without CFRP seismic-retrofit, and under static and dynamic loading conditions. It is shown that CFRP seismic-retrofitting of circular RC bridge pier can also be effective in reducing the vulnerability under lateral impact loading. The CFRP-retrofit approach adopted in this study meets the requirement of multi-hazard prevention improving the robustness of the bridge. Finally, a semi-empirical equation for predicting the maximum displacement under impact loading is derived based on experimental results. The proposed equation adopts the results of a static test as a proxy for assessing the dynamic behavior allowing for the design of the required shear and flexural load-carrying capacity.

Influence Of Pier Height On The Effectiveness Of Seismic Isolation Of Friction Pendulum Bearing For Single-Track Railway Bridges

Stochastic seismic responses analysis of long-span rigid-framed bridge with high piers considering travelling wave effect

Seismic Response of Isolated Railway Bridge Subjected to Near-fault Ground Motion

Shaking table tests and numerical studies on the seismic behaviors of FPB in railway continuous beam bridges

Effect of Rail Restraints on Seismic Responses of Cushioning Railway Bridges

Three-dimensional finite element modelling for seismic response analysis of pile-supported bridges

Effectiveness of CFRP Seismic-Retrofit of Circular RC Bridge Piers under Vehicular Lateral Impact Loading

Seismic Analysis of Coupled High-Speed Train-Bridge with the Isolation of Friction Pendulum Bearing

Seismic isolation effect of a new type of friction pendulum bearing in high-speed railway girder bridge

Study on Seismic Isolation of Long Span Double Deck Steel Truss Continuous Girder Bridge

Study on the pier bottom self-centering seismic isolation structure of the high-pier continuous rigid frame bridges

A Kind of Simplified Design Approach for Girder Bridge Isolated by Triple Friction Pendulum Bearing

Seismic Isolation Design for Long-span Prestressed Concrete Continuous Girder Bridge

Advances and challenges in friction pendulum bearings for seismic isolation systems

Shaking table tests of base-isolated reinforced concrete frame by double friction pendulum bearings

Seismic response characteristics of bridges using double concave friction pendulum bearings with tri-linear behavior

Analysis of Influence of Tie Beam on Seismic Performance of Double Leg Thin-walled High Piers

Seismic Analysis of Long Span Continuous Rigid-Frame Bridge with Thin-Walled High Piers

Seismic Control of Benchmark Cable-Stayed Bridges Using Variable Friction Pendulum Isolator

Seismic Performance of Polynomial Friction Pendulum Isolator (PFPI) on Benchmark Cable-Stayed Bridge

Evaluation of isolation performance of, reticulated shell structures with curvature-consistent frictional pendulum isolation system through shaking table tests