Abstract:In order to improve the seismic performance of a continuous bridge, we propose to install self-centering functional separation bearings (Sc-FSB) between the fixed pier and the girder in the bridge. Following the design idea of separating functionalities, the Sc-FSB device is primarily composed of a sliding bearing to bear vertical load, a friction cable to carry horizontal seismic force and dissipate the seismic energy input into the superstructure, and self-centering springs to achieve post-earthquake self-centering effects. In this study, the Sc-FSB device's hysteretic model is established, and its theoretical formula is deduced. The quasi-static cyclic tests of 10 Sc-FSB device specimens were performed to verify their promising mechanical performances, in which we consider parameters of two friction cables with different diameters and three self-centering springs with different stiffnesses. The results show that the Sc-FSB device holds excellent characteristics of a typical friction damper, such as relatively stable outputs, good energy dissipation and deformation capacity under all working conditions, and its fatigue performance meets the requirements of typical specifications. In addition, several unique features of the Sc-FSB are identified as follows. The maximum damping force is independent of the loading frequency, and it increases with the displacement amplitude. The damping force is significantly affected by the pre-tension force of the friction cable and the number of winding coils, and as a result, the energy dissipation performance is promising. The stiffness and pre-tension force of the self-centering spring significantly improve the self-centering ability of the Sc-FSB device. The design of friction cable and self-centering spring effectively separates the functions of bearings. This study can serve as a foundation for the further study of Sc-FSB device and as a reference for the research of other similar friction dampers.

Seismic response characteristics of bridges using double concave friction pendulum bearings with tri-linear behavior

Seismic Response of Isolated Railway Bridge Subjected to Near-fault Ground Motion

Analysis and design of double friction pendulum systems for seismic isolation

Seismic isolation effect of a new type of friction pendulum bearing in high-speed railway girder bridge

Study on Seismic Isolation of Long Span Double Deck Steel Truss Continuous Girder Bridge

Seismic Analysis of Coupled High-Speed Train-Bridge with the Isolation of Friction Pendulum Bearing

Shaking table tests and numerical studies on the seismic behaviors of FPB in railway continuous beam bridges

A Kind of Simplified Design Approach for Girder Bridge Isolated by Triple Friction Pendulum Bearing

Shaking table tests of base-isolated reinforced concrete frame by double friction pendulum bearings

Advances and challenges in friction pendulum bearings for seismic isolation systems

Seismic Isolation Design for Long-span Prestressed Concrete Continuous Girder Bridge

Quasi-static cyclic loading experiment and analysis of mechanical properties of the Sc-FSB

Seismic Control of Benchmark Cable-Stayed Bridges Using Variable Friction Pendulum Isolator

Seismic response of structures with friction pendulum inerter system (FPIS) under near-fault earthquakes

Parametric Study of SMA-based Friction Pendulum System for Response Control of Bridges under Near-Fault Ground Motions

Seismic Study of an Isolated Cable-Stayed Bridge under Near-Fault Ground Motions

A Novel Frictional Sliding Shear Key for the Transverse Seismic Mitigation of Girder Bridges

A SMA-based sliding friction damper for enhancing the transverse seismic performance of isolated bridges

Mechanical Behaviors of a Buckling-Plate Self-Centering Friction Damper

3D response simulation of a bridge with a posttensioned base rocking steel pier under sequential loading of traffic loads, braking force, and earthquake excitations

Seismic displacement response analysis of Friction Pendulum Bearing under friction coupling and collision effects