Abstract:A novel self-centering friction damper with variable slip stiffness (VSFD) is proposed to achieve ideal self-centering capability and limit the responses of the brace frame structure under the extremely rarely occurring earthquake (EROE), and its critical difference from the self-centering friction damper with constant slip stiffness (CSFD) is the hardening post-yielding stiffness. Through mechanical analysis, the VSFD exhibits ideal flag-shaped hysteretic behavior with the desired self-centering and energy dissipation capacity. The experimental study confirms that the hysteretic behavior of the VSFD is affected by friction coefficient, slope angle and transverse compressive force. The combination of disc spring stacks with various stiffness can provide variable compressive stiffness for the VSFD. The ratio of the residual sliding load to the initial sliding load increases with pre-compressive force, and so does the self-centering capacity. The hardening post-yielding stiffness ratio is proportional to the ratio of strong to weak stacks of the disc springs. The displacement corresponding to the hardening point decreases as the preloading weak stacks’ deformation capacity decreases. The VSFD can dissipate energy even if the deformation is small, and the damping ratio drops with increasing deformation, pre-compressive force and compressive stiffness. The updated displacement-based design procedure is proposed and the comparative dynamic time history analysis is conducted for the brace frames with different kinds of braces. The results show that the seismic responses of brace frames with the CSFDs and VSFDs are comparable under the rarely occurring earthquake (ROE), which meet the performance objectives, while the latter has smaller displacement response and larger floor acceleration than the former owing to its hardening post-yielding stiffness. Due to the considerable residual deformation under the ROE and EROE, the response of brace frame with the conventional friction dampers (CFDs) differs dramatically.

A SMA-based sliding friction damper for enhancing the transverse seismic performance of isolated bridges

A Novel Frictional Sliding Shear Key for the Transverse Seismic Mitigation of Girder Bridges

SEISMIC DESIGN METHOD OF SMALL AND MEDIUM SPAN BRIDGE CONSIDERING BEARING FRICTION SLIPPING

Yielding Steel Dampers as Restraining Devices to Control Seismic Sliding of Laminated Rubber Bearings for Highway Bridges: Analytical and Experimental Study

Seismic performance of bridges with novel SMA cable‐restrained high damping rubber bearings against near‐fault ground motions

Quasi-static cyclic loading experiment and analysis of mechanical properties of the Sc-FSB

Utilizing yielding steel dampers to mitigate transverse seismic irregularity of a multispan continuous bridge with unequal height piers

Resilience-based performance and design of SMA/sliding bearing isolation system for highway bridges

Utilizing a new self-centering hysteresis model to assess the seismic vulnerability of a long-span cable-stayed bridge equipped with SMA wire-based roller bearings

Study on unseating prevention for multi-union long simply supported girder bridges under near-fault ground motions

Development of Steel Dampers for Bridges to Allow Large Displacement Through a Vertical Free Mechanism

Seismic performance improvement of continuous rigid-frame bridges with hybrid control system under near-fault ground motions

Seismic resilience of RC bridge with self-centering energy dissipation braces using SMA U-shaped plates

Parametric Study of SMA-based Friction Pendulum System for Response Control of Bridges under Near-Fault Ground Motions

Performance-based seismic design and optimization of damper devices for cable-stayed bridge

Study on the damping efficiency of continuous beam bridge with constant cross-section applied by lead rubber bearings and fluid viscous dampers

Feasibility simulation of aseismic structure design for long-span bridges

Concept and numerical analysis of a double-stage coupling damper for multilevel seismic protection

Seismic performance assessment of RC bridge piers with variable hysteresis performance dampers

Enhancing seismic performance of brace frame using self-centering friction damper with variable slip stiffness

Study on Seismic Isolation of Long Span Double Deck Steel Truss Continuous Girder Bridge