Abstract:Publication date: 22 July 2022 Source: Key Engineering Materials Vol. 926 Author(s): Jonas Reblitz, Franz Reuther, Ricardo Trân, Verena Kräusel, Marion Merklein The reduction of weight is crucial in the automotive sector to reach a lower energy consumption and an increased range, especially for electrically powered vehicles. In this regard, body-in-white parts offer a high potential for the application of lightweight construction. The required weight savings can be achieved by implementing parts with a high strength-to-weight ratio. A promising approach is the combination of lightweight materials and lightweight design, which can be realized by tubular components made of high strength aluminum. Due to their structural stiffness and high crashworthiness, those structures are often used as safety-relevant car body components. However, the material characterization of tube profiles is a major challenge, which in turn impedes an accurate numerical simulation and precise process design. In contrast to flat semi-finished parts, various effects of the production process and the geometry, regarding the stress state under load, must be taken into account. For this purpose, adapted testing methods considering the geometrical and mechanical properties of the tubular parts have to be investigated, in order to generate an accurate material model and process design. Within this research work, tubular components made out of AA7020 in W-temper condition were used to analyze the mechanical properties. In this regard, several tensile specimens are milled from a tube, so they also have a curvature profile. The experimental tensile tests have been performed at different strain rates by using an universal testing machine from type Gleeble 3500. To ensure a proper measurement of the mechanical properties, the clamping jaws of the testing machine are adjusted to the curved samples. The investigated material parameters are subsequently transferred to an FE-Model with curved specimen to enable an accurate prediction of the forming behavior. In addition, an FE model of a flat tensile specimen was also created for comparison, in order to gain a profound knowledge regarding the influence of the geometric and mechanical properties of tubular components.

Investigation on Lightweight Performance of Tubular Rivet-Reinforced Joints for Joining AA5052 Sheets

Mechanical properties of tubular rivet-reinforced joints realized with different reinforcing loads

Influence of thickness combinations on mechanical properties of joints produced by clinch riveting with rigid rivet

Experimental study of the static behavior of tubular N-joints

Microstructure evolution of AA5052 joint failure process and mechanical performance after reconditioning with tubular rivet

Effect of edge riveting on the failure mechanism and mechanical properties of self-piercing riveted aluminium joints

Mechanical Properties of B1500HS/AA5052 Joints by Self-Piercing Riveting

Formation mechanism and mechanical strength evaluation of hybrid riveted/solid-state bonded aluminium alloy joint

Investigation of the Restored Joint for Aluminum Alloy

Investigation of Joint Quality 980 MPa Grade GA Steel Sheet and 5052 Aluminum Alloy by Electromagnetic Self-Piercing Riveting

Friction forge riveting of AA7075-T6 sheets with large diameter 2117-T3 rivets

Effect of blank holder force on joining quality of the flat clinch-rivet process

The Energy Consumption of the Process of Joining Steel Sheets with the Use of Clinching With and Without an Additional Rivet, and Analysis of Sheet Deformation and Mechanical Strength of Joints

Towards joinability of thermal self-piercing riveting for AA7075-T6 aluminum alloy sheets under quasi-static loading conditions

Influence of sheet thickness on mechanical behaviors of the clinched joints produced by single-point butt clinching process

Simulation and Analysis of Self-Piercing Riveting Process in Aluminum Sheets

Numerical and Experimental Investigations on the Mechanical Properties of Milled Specimens from an AA7020 Tube

Effect of process parameters on joint quality and mechanical properties of local-thickened self-piercing riveted steel and die-casting aluminum joints

Performance Tests of HX340 Microalloyed Steel Sheets Joined Using Clinch-Rivet Technology

Friction stir riveting (FSR) of AA6061-T6 aluminum alloy and DP600 steel

Study of Mechanical Properties and Failure Mechanism of CFRP-Aluminum Alloy Self-Piercing Riveted-Adhesive Joints