Abstract:Two kinds of crystalline/amorphous nanolaminates (C/ANLs), i.e., Ag/Cu-Zr and Mo/Cu-Zr, with a wide range of modulation ratios (thickness ratio of the amorphous layer to the crystalline layer) from 0.1 up to 9.0 were, respectively, prepared using magnetron sputtering. The hardness and the strain rate sensitivity m were measured for comparison through nanoindentation testing. The mechanical properties displayed a strong -dependence, which was tuned by the crystalline phases. With the increase of , the hardness increased in the Ag/Cu-Zr nanolaminates while it decreased in the Mo/Cu-Zr ones. However, the two C/ANLs showed similar variations in m that was reduced gradually from positive values at small to negative values at large . Microstructural examination demonstrated that the amorphous Cu-Zr layers in both the C/ANLs showed a deformation-induced crystallization (DIC) phenomenon within the nanoindentation deformation zone. The DIC was highly dependent on and became more intense in the Mo/Cu-Zr than in the Ag/Cu-Zr C/ANLs. The - and constituent-dependent DIC behaviors were rationalized in light of the stress field applied on the amorphous layers that is sensitive to both the amorphous layer thickness and the crystalline constituents. This DIC-induced negative m in amorphous layers competed with the positive m in crystalline layers, leading to a negative-to-positive change in m on reducing . The underlying deformation mechanism was revealed to be the cooperation between dislocation activities in the crystalline layers and shear transformation zone motions in the amorphous layers. Furthermore, a modified mechanistic model was utilized to quantitatively describe the -dependent hardness at different crystalline constituents.

Rate Sensitivity and Deformation Mechanism of Semi‐crystalline Polymers During Instrumented Indentation

Research on Viscoelastic Behavior of Semi‐crystalline Polymers Using Instrumented Indentation

Characterizing Multi Mechanical Behaviors for Epoxy-Like Materials under Wide Strain Rate Range

Rate-dependent Constitutive Behavior and Mechanism of CMDB under Tension Loading

Strain Rate Sensitivity Measured from Different Continuous Macro-indentation Methods

Characterization of Strain Rate Sensitivity and Activation Volume Using the Indentation Relaxation Test

Strain Hardening Behaviors and Mechanisms of Polyurethane under Various Strain Rate Loading

Influence of Friction in Material Characterization in Microindentation Measurement.

In Situ Nanoindentation Mechanical Property of Films by Atomic Force Microscope

Crystal plasticity assessment of the effect of material parameters on contact depth during spherical indentation

An Unexpected Plasticization Phenomenon and a Constant of the Change Rate of Viscoelastic Properties for Polymers During Nanoindentation Test

Sensitivity Of Pmma Nanoindentation Measurements To Strain Rate

A Crystal Plasticity Based Strain Rate Dependent Model Across an Ultra-wide Range

Mechanical Characterization and Strain-Rate Sensitivity Measurement of Ti-7333 Alloy Based on Nanoindentation and Crystal Plasticity Modeling

An MD Simulation Study to the Indentation Size Effect of Polystyrene and Polyethylene with Various Indenter Shapes and Loading Rates

Effect of Indentation Size on Strain Rate Sensitivity of Zirconia Ceramics by Nanoindentation

Elastic Contact Versus Indentation Modeling of Multilayered Materials

Probing The Size- And Constituent-Mediated Mechanical Properties And Deformation Behavior In Crystalline/Amorphous Nanolaminates

Investigation of in-plane visco-deformation in PMMA indentation via TLV model calibrated with tensile specimens

Measurement of Viscoelastic Properties for Polymers by Nanoindentation

A Multi-Sphere Indentation Method to Determine Young's Modulus of Soft Polymeric Materials Based on the Johnson–Kendall–Roberts Contact Model