Abstract:We report on the difficulties of extracting plastic parameters from constitutive equations derived by instrumented indentation tests on hard and stiff materials at shallow depths of penetration. As a general rule, we refer here to materials with an elastic stiffness more than 10 % of that of the indenter and a yield strain higher than 1 %, as well as to penetration depths less than ∼ 5 times the characteristic tip defect length of the indenter. We experimentally tested such a material (an amorphous alloy) by nanoindentation. To describe the mechanical response of the test, namely the force-displacement curve, it is necessary to consider the combined effects of indenter tip imperfections and indenter deformability. For this purpose, an identification procedure has been carried out by performing numerical simulations (using Finite Element Analysis) with constitutive equations that are known to satisfactorily describe the behaviour of the tested material. We propose a straightforward procedure to address indenter tip imperfection and deformability, which consists of firstly taking account of a deformable indenter in the numerical simulations. This procedure also involves modifying the experimental curve by considering a truncated length to create artificially the material’s response to a perfectly sharp indentation. The truncated length is determined directly from the loading part of the force-displacement curve. We also show that ignoring one or both of these issues results in large errors in the plastic parameters extracted from the data.

Influence of Friction in Material Characterization in Microindentation Measurement.

Influence of Friction on Imperfect Conical Indentation for Elastoplastic Material

The Effect of Friction on Indentation Test Results

Friction Effect on Micro-indentation Measurement with Different Indenters

The Effect of Indenter Angle on the Microindentation Hardness

Study of the Ratcheting by the Indentation Fatigue Method with a Flat Cylindrical Indenter: Part I. Experimental Study

Indentation hardness of the cohesive-frictional materials

The Influence of Indenter Tip Imperfection and Deformability on Analysing Instrumented Indentation Tests at Shallow Depths of Penetration on Stiff and Hard Materials

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

On the study of mystical materials identified by indentation on power law and Voce hardening solids

On Determination of Elastic Modulus and Indentation Hardness by Instrumented Spherical Indentation: Influence of Surface Roughness and Correction Method

The effects of friction and specimen thickness on the measurement of biological specimen elasticity with indentation method

Influence of Indenter Tip Roundness on Hardness Behavior in Nanoindentation

Crystal plasticity assessment of the effect of material parameters on contact depth during spherical indentation

A Numerical Study Of Indentation Elastic-Plastic Behaviors Based On Indenters Of Different Geometry

The Role of Friction to the Indentation Size Effect in Amorphous and Crystallized Pd-Based Alloy

Effect of normal load and roughness on the nanoscale friction coefficient in the elastic and plastic contact regime

Identification of plastic properties through spherical indentation

Assessing the Elastic Parameters and Energy-Dissipation Capacity of Solid Materials: A Residual Indent May Tell All

The Influence of Indenter Tip Radius on the Micro-Indentation Hardness

Investigation of the overall friction coefficient in single-pass scratch test