Abstract:Summary Depth-sensing instrumented indentation tests are widely used to probe the mechanical properties of materials at a local area and small scales. Generally, indented solid was assumed semi-infinite plane solid because the contact region is small comparing the indented solid. However, for some biomaterial, such as skin, cornea and sclera, the effect of the curvature of the surface cannot be ignored. Using systematic finite element analysis and dimensional analysis, a method to determine the elastic modulus of the materials with curved surface is proposed using flat punch indentation in this paper. An axisymmetric, two-dimensional model was adopted and four-node bilinear axisymmetric elements with reduced integration and hourglass control were used to model the semi-infinite solid. The boundary conditions were such that the outer surface nodes were traction-free with fixed lower surface nodes. The size of the indented solid is taken to be large enough compared with the maximum contact radius, thus the boundary conditions basically have no effect on the computational results. . The material is assumes as linear elastic materials with the Poisson’s ratio 0.49. Then, the indention force can be expressed as a function, including the elastic modulus of the indented solid, the indentor radius, the indentation depth and the curvature radius of the indented solid. According to the dimensional analysis and finite element analysis, for a certain ratio value of indentation depth to the indentor radius, a dimensionless function expression of indention force can be obtained. Then, the elastic modulus can be determined using dimensionless function and the indentation test. It is shown from the results that the effect of the curvature will reduce with the ratio value of indentor radius to curvature radius of the indented solid.

The Effect of Friction on Indentation Test Results

Friction Effect on Micro-indentation Measurement with Different Indenters

The Effect of Indenter Angle on the Microindentation Hardness

Equivalency of Berkovich and conical load-indentation curves

Indentation hardness of the cohesive-frictional materials

The Influence of Indenter Tip Imperfection and Deformability on Analysing Instrumented Indentation Tests at Shallow Depths of Penetration on Stiff and Hard Materials

Effect of the curvature for the indented solid with curved surface using flat punch indentation

Investigation of the overall friction coefficient in single-pass scratch test

Surface Effects on the Indentation of a Soft Layer on a Rigid Substrate with an Elliptical Cylinder Indenter

Elastic Contact Versus Indentation Modeling of Multilayered Materials

Effect of normal load and roughness on the nanoscale friction coefficient in the elastic and plastic contact regime

Controlling the Friction Coefficient and Adhesive Properties of a Contact by Varying the Indenter Geometry

Reverse analysis via efficient artificial neural networks based on simulated Berkovich indentation considering effects of friction

Indentation of Irreversibly Compressible Material: Computer Simulation

An Indentation Method to Determine the Constitutive Parameters of Hyperelastic Films under Large Deformation: Theoretical Model, Experiments and Simulations

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Influence of Indenter Tip Roundness on Hardness Behavior in Nanoindentation

Analysis of the Nanoindentation Data Measured with a Berkovich Indenter for Brittle Materials: Effect of the Residual Contact Stress

Friction in Adhesive Contact Between a Rough Hard Indenter and Smooth Soft Elastomer Layer

Self-consistent approximations for the frictionless paraboloidal and conical depth-sensing indentation: The generalized bottom effect

Simulation of instrumented indentation and material characterization