Abstract:We report on the difficulties of extracting plastic parameters from constitutive equations derived by instrumented indentation tests on hard and stiff materials at shallow depths of penetration. As a general rule, we refer here to materials with an elastic stiffness more than 10 % of that of the indenter and a yield strain higher than 1 %, as well as to penetration depths less than ∼ 5 times the characteristic tip defect length of the indenter. We experimentally tested such a material (an amorphous alloy) by nanoindentation. To describe the mechanical response of the test, namely the force-displacement curve, it is necessary to consider the combined effects of indenter tip imperfections and indenter deformability. For this purpose, an identification procedure has been carried out by performing numerical simulations (using Finite Element Analysis) with constitutive equations that are known to satisfactorily describe the behaviour of the tested material. We propose a straightforward procedure to address indenter tip imperfection and deformability, which consists of firstly taking account of a deformable indenter in the numerical simulations. This procedure also involves modifying the experimental curve by considering a truncated length to create artificially the material’s response to a perfectly sharp indentation. The truncated length is determined directly from the loading part of the force-displacement curve. We also show that ignoring one or both of these issues results in large errors in the plastic parameters extracted from the data.

Indentation of Irreversibly Compressible Material: Computer Simulation

Indentation Size Effect: A Study Via The Mechanism-Based Strain-Gradient Plasticity Theory

The Effect of Friction on Indentation Test Results

Indentation of circular hyperelastic membrane with hole by cylindrical indenter

PRISMS-Indentation: Multi-scale Elasto-Plastic Virtual Indentation Module

A Numerical Study of Indentation with Small Spherical Indenters

The Indentation Elastic Response - Indentation Shape and the Stress Distribution

The Influence of Indenter Tip Imperfection and Deformability on Analysing Instrumented Indentation Tests at Shallow Depths of Penetration on Stiff and Hard Materials

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Indentation of a Compressible Soft Electroactive Half-Space: Some Theoretical Aspects

Friction Effect on Micro-indentation Measurement with Different Indenters

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

A Critical Appraisal of the Instrumented Indentation Technique and Profilometry‐Based Inverse Finite Element Method Indentation Plastometry for Obtaining Stress–Strain Curves

Axisymmetric Indentation of Curved Elastic Membranes by a Convex Rigid Indenter

Indentation Of A Transversely Isotropic Thermoporoelastic Half-Space By A Rigid Circular Cylindrical Punch

Simulation of instrumented indentation and material characterization

Identification of plastic properties through spherical indentation

Indentation on a transversely isotropic half-space of multiferroic composite medium with a circular contact region

Equivalency of Berkovich and conical load-indentation curves

Determining plastic properties of a material with residual stress by using conical indentation