Abstract:In this paper, a simplified thermodynamics analysis of cyclic plastic deformation is performed in order to establish an energy transition relation for describing the elastic–plastic stress and strain behavior of the notch-tip material element in bodies subjected to multiaxial cyclic loads. Based on the thermodynamics analysis, it is deduced that in the case of elastic–plastic deformation, Neuber’s rule inevitably overestimates the actual stress and strain at the notch tip, while the equivalent strain energy density (ESED) method tends to underestimate the actual notch-tip stress and strain. According to the actual energy conversion occurring in the notch-tip material element during cyclic plastic deformation, a unified expression for estimating the elastic–plastic notch stress–strain responses in bodies subjected to multiaxial cyclic loads is developed, of which Neuber’s rule and the ESED method become two particular cases, i.e. upper and lower bound limits of the notch stress and strain estimations. This expression is verified experimentally under both proportional and non-proportional multiaxial cyclic loads and a good agreement between the calculated and the measured notch strains has been achieved. It is also shown that in the case of multiaxial cyclic loading, the unified expression distinctly improves the accuracy of the notch-tip stress–strain estimations in comparison with Neuber’s rule and the ESED method. The unified expression of the notch stress–strain calculation developed in this paper can thus provide a more logical approximate approach for estimating the elastic–plastic notch-tip stress and strain responses of components subjected to lengthy multiaxial cyclic loading histories for local strain approach-based fatigue-crack-initiation life prediction.

Sharp V‐notches in Viscoplastic Solids: Strain Energy Rate Density Rule and Fracture Toughness

Three-dimensional Sharp V-notch Stress Intensity Factor and Strain Energy Rate Density under Creeping Conditions

Further Investigation of Neuber's Rule and the Equivalent Strain Energy Density (ESED) Method

A unified expression of elastic-plastic notch stress-strain calculation in bodies subjected to multiaxial cyclic loading

Elasto-plastic fracture criterion for structural components with sharp V-shaped notches

Notch Stress Intensity Factor and C-integral Evaluation for Sharp V-notch in Power-Law Creeping Solids

A Local Approach for Fracture Analysis of V- Notch Specimens under Mode-I Loading

Estimation of Stress Field for Sharp V-notch in Power-Law Creeping Solids: an Asymptotic Viewpoint

Effects Of Notch Geometry On The Local Cleavage Fracture Stress Sigma(F)

A concise review about fracture assessments of brittle solids with V-notches

The single edge notch fracture test for viscoelastic elastomers

Plane Stress Sharp V-notch Tip Field in Power-Law Creeping Solids

On the Second Order Term Asymptotic Solution for Sharp V-notch Tip Field in Elasto-Viscoplastic Solids

Analysis of Elastoplastic Sharp Notches

Fracture prediction in flat PMMA notched specimens under tension - effectiveness of the equivalent material concept and fictitious material concept

Dynamic brittle fracture in sharp V-notched rock specimens using digital image correlation method

Fracture assessments of blunt V-notches using the coherent gradient sensing (CGS) method

Evolution of fracture mechanics parameters relevant to narrow notch increment as a measure of fatigue damage accumulation

Energy release rate of a single edge cracked specimen subjected to large deformation

Experimental Studies on Fracture of Unidirectional Glass-Fibre-Reinforced Plastics Composites with V-Notch

Experimental Study on Fracture Behavior of Adhesive-Bonded Structure with V-notch Based on Digital Gradient Sensing Method