Abstract:This graphical abstract presents a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B architecture, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage, an OTA‐based RC integrator with anti‐aliasing properties, is chopped to mitigate offset and 1/f noise, while the second stage employs a switched‐capacitor integrator with OTA‐sharing to reduce complexity and enable signal addition before quantization. Fabricated in a 180‐nm CMOS process, the DSM achieves a 103 dB dynamic range in a 100 Hz bandwidth, with peak SNDR, SNR, and SFDR values of 95.8 dB, 97.1 dB, and 102.8 dB, respectively, and consumes 10.7 μ A from a 1.8 V supply. The Schreier figure‐of‐merit (FoMs) is 170.2 dB, highlighting its energy efficiency. This paper reports a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B topology, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage is an OTA‐based RC integrator with inherent anti‐aliasing properties, while the second stage is a switched‐capacitor integrator. Offset and 1/f noise in the first stage are mitigated by the chopper‐stabilization technique, while those in the second stage are suppressed through the gain provided by the first stage. Furthermore, the OTA‐sharing technology is utilized in the second stage to realize signal addition before quantization, reducing design complexity. The hybrid DSM prototype is fabricated with a 180‐nm CMOS process and occupies an area of 0.123 mm2. Measurement results show peak SNDR/SNR/SFDR values of 95.8, 97.1, and 102.8 dB, respectively, with a current consumption of 10.7 μ A from a 1.8‐V single supply. The reported DSM achieves a 103‐dB dynamic range in a 100‐Hz signal bandwidth, corresponding to a Schreier figure‐of‐merit (FoMs) value of 170.2 dB.

A 0.025mm(2) 0.8v 78.5db-Sndr Vco-Based Sensor Readout Circuit In A Hybrid Pll-Delta Sigma M Structure

A 0.025-mm<sup>2</sup> 0.8-V 78.5dB-SNDR VCO-Based Sensor Readout Circuit in a Hybrid PLL-ΔΣM Structure

A 0.025-Mm 2 0.8-V 78.5-Db SNDR VCO-Based Sensor Readout Circuit in a Hybrid PLL- $\delta\sigma$ M Structure

A Front-End Circuit With 16-Channel 12-Bit 100-Ksps Rc-Hybrid Sar Adc For Industrial Monitoring Application

A 153μw 26nv/√hz Readout Circuit with BW and Power Scalability Using Capacitively-Coupled Chopper Floating Inverter Amplifier Embedded in a Discrete-Time ΔΣ Modulator

A 10.7-Μa 103-Db DR Hybrid Delta-Sigma Modulator for Sensing Applications

A 78.6 Db-Sndr 520Mvpp-Full-scale 620Mω-Zin 105dbcmrr VCO-based Sensor Readout Circuit Using FVF-Based Gm-Input Structure

A 0.8 V Low Power Low Phase-Noise Pll

A 74.5-dB Dynamic Range 10-MHz BW CT-ΔΣ ADC With Distributed-Input VCO and Embedded Capacitive- π Network in 40-nm CMOS

An 81.5Db-Dr 1.25Mhz-Bw VCO-Based CT ΔΣ ADC with Double-PFD Quantizer

A 1.2 mW 67.5 dB SQDR VCO-based ΣΔ ADC with Non-linearity Cancellation Technique

A 1-Gs/s 20 MHz-BW Capacitive-Input Continuous-Time $\delta\sigma$ ADC Using a Novel Parasitic Pole-Mitigated Fully Differential VCO

A Second-Order Purely VCO-Based CT $\delta\sigma$ ADC Using a Modified DPLL Structure in 40-Nm CMOS

A 0.04-Mm2 0.9-Mw 71-Db SNDR Distributed Modular AS ADC with VCO-based Integrator and Digital DAC Calibration

A 1.8mW 2MHz-BW 66.5dB-SNDR ΔΣ ADC using VCO-based integrators with intrinsic CLA

A Compact MEMS Microphone Digital Readout System Using LDO and PPA-Less VCO-Based Delta-Sigma Modulation Technique

A 174.3-Db FoM VCO-Based CT $\delta \sigma $ Modulator with a Fully-Digital Phase Extended Quantizer and Tri-Level Resistor DAC in 130-Nm CMOS

A Compact Square-Geometry Quad-Core 19 GHz Class-F VCO with Parallel Inductor-sharing Technique achieving -137.2 dBc/Hz Phase Noise at 10MHz Offset

A 0.028mm<sup>2</sup> 19.8fJ/step 2<sup>nd</sup>-order VCO-based CT ΔΣ modulator using an inherent passive integrator and capacitive feedback in 40nm CMOS

A 10.7‐μ A 103‐dB DR Hybrid Delta‐Sigma Modulator for Sensing Applications

A 10MHz-BW, 5.6mW, 70dB SNDR ΔΣ ADC using VCO-based integrators with intrinsic DEM